Can Magigoo help remove 3D prints stuck to bed? Let's find out!

Following months of my 3D prints sticking too much to the Ender 3 v2 bed I decided to test out Magigoo to help me get the prints off. Let's find out if it works!
#3dprinting #creality #ender3v2

[@Mr.Random98]

Magigoo is meant to stick when hot and release when cold so it’s odd that it came off easer for you when you heated it up

[@TomUGH-f8w]

I've found clean bed in sink with hot water and dawn dish soap then dry and clean with glass cleaner. After print if it still stuck place the bed with print in freezer and it lifts right off.
I've used these beds for years and had no issue with the print lifting of with ease after it cooled to room temp until recently with a couple new printers that i bought,

[@JGV_IX]

Hi! Thanks for your video! Looking into Magigoo myself... Your Z-offset seems a bit high? Could also help your adhesion if you have better squish on that initial layer. Just an observation - no offence intended.
They indicator for levelling is a game changer - thanks for that!