I have been using this dryer for about ~4 months. Love this thing. Only dryer that actually dries my filament. I primarly print PETG, Nylon and ABS and this is the only one that will actually dry for long term prints. I use this for my 3KG spools and my 1kg spools. Love this thing.
@@Shayway Some of the 3KG spools dont fit but i have found most of them do just fine. If they don't fit its only by a small amount on the top and you can often get by with removing the air diverter from the bottom, but careful cause it can cause a hot patch on your filament and bind it all together.
@@lonewolfsstuck alright so if I put it on 70c for 24hrs + ,a zip up enclosure and, use on a adv 5m how successful do you think that would be able print a nylon ?
@@Shayway Yeah I think the snug fit isnt necessarily a problem, but it is odd. Especially with no handle. And thank you!!! I have huge plans for 2024 :D And of course man, just found you! Ill be sure to watch more :)
I have been using this dryer for about ~4 months. Love this thing. Only dryer that actually dries my filament. I primarly print PETG, Nylon and ABS and this is the only one that will actually dry for long term prints. I use this for my 3KG spools and my 1kg spools. Love this thing.
Didn't even think about 3KG spools, this would be perfect!
@@Shayway Some of the 3KG spools dont fit but i have found most of them do just fine. If they don't fit its only by a small amount on the top and you can often get by with removing the air diverter from the bottom, but careful cause it can cause a hot patch on your filament and bind it all together.
So this will dry out nylon without any extra drying methods ?
@@ohfr20 I use it for Nylon. 70c at 24+ hours (If you set it to 48 hours it just stays on until you turn it off)
@@lonewolfsstuck alright so if I put it on 70c for 24hrs + ,a zip up enclosure and, use on a adv 5m how successful do you think that would be able print a nylon ?
Ive been using his dryer for quite. It's in my opinion the best one out of all of them
How easy does the rolls spin, to print while it's drying?
would it fit a 3kg roll ?
Dang. My fixdry lid was not that tight
It's very snug for sure! Also, love your vids! Thanks for checking out the channel!
@@Shayway Yeah I think the snug fit isnt necessarily a problem, but it is odd. Especially with no handle. And thank you!!! I have huge plans for 2024 :D And of course man, just found you! Ill be sure to watch more :)
Go ahead and print yourself some of those roll desiccant holders that people use in their AMS.
I like the fact you can dry two filaments at once!