Great video, I’m buying one because I saw your video, I’m building a horseshoe pit and in the hole where the stakes goes I have to dig down about 20 inches and there’s rock in there I purchased a 1 inch Masonary drill bit, to help break up the rock I also purchased BOSCH HS1936 16 In. R-Tec Star Point Chisel Twist SDS-max Hammer Steel and a BOSCH HS1935 1 In. x 16 In. R-Tec Flat Chisel SDS-max Hammer Steel. My question is on that variable dial from 1 to 7 that you were talking about where would you set that dial at, when you’re either chiseling or drilling down into rock. Also any technique you would use with those three bits I told you about to help get the rock out of the holes, I would appreciate your advice and expertise, do you recommend using special grease on the drill bits?? Thanks again God Bless.
I liked this test. :) This is what I looked for myself. I would like to know if it is possible to drill a hole in reinforced concrete with a core drill. Respectively, what would be the max size. Can I drill a 150 mm hole with it, which can also be found in the description? Could you possibly make a video of such a test with core drill? I can't find one anywhere on the net. Thanks! :)
Thanks for the video brad, I wasn't too sure what size drill bit you using look like a 2 inch but after seeing how fast is that went through a 4 inch concrete that was pretty fast would like to catch up on some on some more videos on this breaker awesome thanks
I have a video coming out this saturday that is comparing this model to the corded version, i show some breaking with both units. it is a very impressive tool
Great video, I’m buying one because I saw your video, I’m building a horseshoe pit and in the hole where the stakes goes I have to dig down about 20 inches and there’s rock in there I purchased a 1 inch Masonary drill bit, to help break up the rock I also purchased
BOSCH HS1936 16 In. R-Tec Star Point Chisel Twist SDS-max Hammer Steel and a
BOSCH HS1935 1 In. x 16 In. R-Tec Flat Chisel SDS-max Hammer Steel. My question is on that variable dial from 1 to 7 that you were talking about where would you set that dial at, when you’re either chiseling or drilling down into rock. Also any technique you would use with those three bits I told you about to help get the rock out of the holes, I would appreciate your advice and expertise, do you recommend using special grease on the drill bits?? Thanks again God Bless.
I liked this test. :)
This is what I looked for myself.
I would like to know if it is possible to drill a hole in reinforced concrete with a core drill.
Respectively, what would be the max size. Can I drill a 150 mm hole with it, which can also be found in the description?
Could you possibly make a video of such a test with core drill?
I can't find one anywhere on the net.
Thanks! :)
Hello . how long does a battery last?
Thanks for the videos!!!
thanks for watching
Thanks for the video brad, I wasn't too sure what size drill bit you using look like a 2 inch but after seeing how fast is that went through a 4 inch concrete that was pretty fast would like to catch up on some on some more videos on this breaker awesome thanks
DEWALT FLEXVOLT 20V/60V MAX Battery, 12.0-Ah (DCB612) test it out
Will it drive a 10’ ground rod through rocky dirt?
Good test! I’m not sure but I think it could
I wish you would of shown the chisel mode. I want thiso
I have a video coming out this saturday that is comparing this model to the corded version, i show some breaking with both units. it is a very impressive tool
👍🏻👍🏻
Годно!
Looks like you drilling public side walk
That’s an old footing of a house