Parking Sensor Installation Guide

Поделиться
HTML-код
  • Опубликовано: 10 май 2019
  • Hey guys! it's BreakIT FixIT again and we're back with a new video.
    In this video I'll be installing an after market parking sensor on my VW polo. This tutorial can be used on any type of cars.
    I'll be going through a detailed installation of the parking kit as well as giving you a few tricks in order to install it without any sort of complications.
    If you like this video please consider subscribing and give us a thumbs up.
    VW POLO Rear Bumper Removal
    • VW POLO Rear Bumper Re...
    VW POLO Rear Light Removal
    • VW POLO Rear Light Rem...
    Disclaimer:
    Due to factors beyond the control of BreakIT FixIT, I cannot guarantee against improper use or unauthorized modifications of this information. BreakIT FixIT assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. BreakIT FixIT recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of BreakIT FixIT, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not BreakIT FixIT.
    Jellyfish by Declan DP & KODOMOi / declandp
    Licensing Agreement 2.0 (READ)
    www.declandp.info/music-licensing
    Music promoted by Audio Library • Jellyfish - Declan DP ...
  • Авто/МотоАвто/Мото

Комментарии • 31

  • @MrSalamona
    @MrSalamona 3 года назад +8

    Easy, simple and to the point. Thanks

  • @lsiq99
    @lsiq99 Год назад

    What a beautiful video, that was so clear and right to the point.

  • @AndyMarcelin
    @AndyMarcelin 5 лет назад

    thank you! Your doing a great job!

  • @vaughnganas3902
    @vaughnganas3902 3 года назад

    Awesome video. Thanks for good content

  • @symonlois6156
    @symonlois6156 4 года назад +1

    clear video.

  • @sl-jl3pz
    @sl-jl3pz 2 года назад

    well explained

  • @AbdoJouma
    @AbdoJouma 3 года назад

    Hi man. I also have a polo (2010, do you have the measurements of where I need to drill the holes?
    Also my car in the UK has only one reverse light on the left side, so do i connect it there? If that's the case then what are the colours for the wires please?
    Thanks for the good video

  • @cavela62
    @cavela62 2 года назад

    Hvala drug!!!

  • @Kalash9777
    @Kalash9777 3 года назад

    hey would you please make a video how to change the color of your door handle from black to the color of your car, my polo is gray but also has black door handles, how can you change it to the color of your car

  • @uvejssokoli4620
    @uvejssokoli4620 24 дня назад

    where did you connect the black ground cable?

  • @rnkaushal2
    @rnkaushal2 5 лет назад

    Hi
    Great vid. But won’t the module that you hid behind boot lining make a clatter when you drive?

  • @FahadKhan-me8jq
    @FahadKhan-me8jq 4 года назад

    I couldn’t see what colour you connected the red wire to?

  • @AlicanCinarr
    @AlicanCinarr 4 года назад +2

    What is the earth cable color?

  • @syed2694
    @syed2694 4 года назад

    Hey man, I had a problem with mine, I have a VW Polo 2012 and when I used my multimeter to check the voltage at the reversing lights, 2 different wires had a 12V supply, not just one. One was green-black and the other was blue-black. I decided to go with blue-black, the sensors worked for a bit then stopped working

    • @syed2694
      @syed2694 4 года назад

      @@breakitfixit1046 hey man, it seems to have started working fine again, my battery had actually died and I had to call autoguard for roadside assistance. Once the guy jumpstarted my battery, it was fine. Thanks for the speedy reply, I really appreciate it.

  • @ghazibagazi9687
    @ghazibagazi9687 3 года назад

    From where I can buy them please?

  • @elyazidazghiri9643
    @elyazidazghiri9643 4 года назад +1

    Is this parking sensors did you show are a good quality ?

    • @makingcookingfixing
      @makingcookingfixing 3 года назад

      I had the same unit installed new, and it sucks terribly, see my video: ruclips.net/video/-XrS1T3M5tk/видео.html

  • @ianledina8282
    @ianledina8282 3 года назад

    Sir, what is the hight from the ground to the bumper you will put the sensor?

    • @ianledina8282
      @ianledina8282 3 года назад

      @@breakitfixit1046 the hight of my car bumper from the ground or floor is 22inches max, and the instruction i've search is .6 - .8m, frm. The ground.
      My bumper is a little bit short in hight the max hight I can put the sensor in my bumper is 20inches.
      Will the sensor will work ok
      My car is old 1998 toyota corolla.
      Thanks!

    • @ianledina8282
      @ianledina8282 3 года назад

      @@breakitfixit1046 thank you sir,
      But what is the height from the ground or the base/ flooring, should I put the sensor. Is 20inches from the ground works.

  • @CarryoutSummer
    @CarryoutSummer 4 года назад

    good friend, where does the ground link??

    • @CarryoutSummer
      @CarryoutSummer 4 года назад

      @@breakitfixit1046 thanks bro 💪💪💪

  • @lsiq99
    @lsiq99 Год назад

    Could you put the link of that kit please? New sub here!

  • @sharkfinn6469
    @sharkfinn6469 Год назад

    Attempted this today.
    There is markings on the inside of my bumper. Much easier than Having to measure. Too late for me. Hopefully this helps someone

  • @nidhushan1383
    @nidhushan1383 4 года назад

    Where do I buy parking sensor from

  • @buddima_j
    @buddima_j 4 года назад

    is this brakes atomatically

  • @esmailfawaz3581
    @esmailfawaz3581 3 года назад

    دا انجليزي دا يا مرسى 😁