How To Replace the Axle Bearings on a Yamaha Blaster 200

[@GeppyGep]

Thanks for the video and my questions about the warrior. Basically the same rear end?

[@sixnine2818]

Thank you so much!!!!!!!!!!!!!!!

[@drumboon1986]

What is the best way to remove a stuck sprocket flange on a atv it’s a lt230s

[@rmatvmc]

If it's stuck on there, try some heat and let some penetrating oil soak in like Maxima MPPL or WD-40. -Charles

[@drumboon1986]

@@rmatvmc thanks

[@christianjarceaguilar209]

Thank you!!!!!

[@coltonemmert8393]

I have to replace my axle hub and i can’t find the correct piece online, do you have any suggestions on where to get one?

[@rmatvmc]

You should be able to locate it on the OEM parts finder here: www.rockymountainatvmc.com/oem-parts/Yamaha

[@Chevro91]

@@rmatvmc Is the tusk
(one piece) designed Axle nut superior or as committed to holding a axle fit and snug Over the oem design that uses two axle nuts as a jamb nut

[@Chevro91]

Or any motor sports dealership has an oem parts finder page on their website that illustrates the break down and schematic of each sector of the bike or atv . Not hard to find . Look at the parts break down and find the parts Oem # number . Some parts have superceded numbers meaning a new updated number

[@Chevro91]

Meaning does it keep the sprocket hub snug in place against the carrier and not allow for any premature loosening weather it is a month or a year of riding . I can’t see the superiority in that (single) style axle nut over the oem design jamb nuts

[@sulliandtylergarage1745]

My collar was seized on it, i cut it off but with my new one it gas a weld line inside of it, and i cant put it on correctly, how badly do i need the collar and what exactly does it do?

[@FRAN507_franluis507pa]

What bearing use that axle ?

[@زيادزياد-ق5ح2ع]

Hi ... the shaft sem banshee I think

[@26zilence]

I installed new bearings but is hard to spin the axle. Bad?