When you offset the curve at 2:22, I got an error saying that the offset curve must be provided if the curve is not planar itself, but is there any work around for this? I'm not exactly sure why this is happening as everything else is coded the same... Thank you in advance!
@@DCOParametric Thank you so much for the reply! It was fixed with planexy but it started interfering with the inner wall extrusion later on where only one side of the walls would show up.
When you offset the curve at 2:22, I got an error saying that the offset curve must be provided if the curve is not planar itself, but is there any work around for this? I'm not exactly sure why this is happening as everything else is coded the same...
Thank you in advance!
sometimes you need to use a plane reference to offset. use planexy, and that may fix the issue.
@@DCOParametric Thank you so much for the reply! It was fixed with planexy but it started interfering with the inner wall extrusion later on where only one side of the walls would show up.
How do the knots stand out in green? (the editable ones)
When you select the component it turns green
Thanx