Flick key over full sized ones. But , original ones can be quite expensive. Not sure will original or Silca ones will allow simple thing such as board replacement , so You could save a lot by not having to reprogram / copy actual chip. As for flick button part , well , there's no solution for that , but it's easier after all to have (or nearly have) half of key in pocket than fully sized one that is longer than any other key on keychain.
Flick key over full sized ones. But , original ones can be quite expensive. Not sure will original or Silca ones will allow simple thing such as board replacement , so You could save a lot by not having to reprogram / copy actual chip. As for flick button part , well , there's no solution for that , but it's easier after all to have (or nearly have) half of key in pocket than fully sized one that is longer than any other key on keychain.
so you cannot port the blade from old to new case?? it's too bad
I did mine successfully, there was a small pin at base of blade. Simply knock that through (don't lose it! Swap blade and replace. Hope that helps.