Amazing, i really enjoy this. I was looking at the products very confused but the clears so much out. Well done, i can tell there was effort put in here
Can I take out my sprinklers T200 before winter and leave just pipline in the ground? I have installed two drain valves but i am afraid that i would find broken sprinklers when spring comes..👍🏼 thanks!
Hello Gardena Fan, By using the drainage valve at the lowest point, the complete system becomes frost-proof. The sprinklers do not have to be disassembled. Best regards GARDENA Service
Hallo Melih, vielen Dank für Deine Nachfrage. Wenn Du die Ventilbox mit Ventilen einbaust kannst Du auf den Bewässerungscomputer GARDENA smart Water Control verzichten. Zur Ansteuerung der 24 Volt Ventile in der Ventilbox wird allerdings die GARDENA smart irrigation control benötigt. Viele Grüße aus Ulm GARDENA Service
Hi I want to install a decent / professional / pop up sprinkler system in my garden, that is connected to a timer. Do you know what I should do? I just need to know, 1' how many sprinklers I need 2' what kind of sprinkler exactly is best 3' where to ideally locate the sprinklers I have a picture s of my garden and the sizes of / dimensions if I emailed them to you could you advise me thanks
Hello Gardena Fan, thanks for your message. For the OS 140, the consumption value of 22 must always be taken into calculation. Best regards from Germany GARDENA Service
Hello Gardena Fan, thank you for your question. When a sprinkler no longer rotates and remains in place, experience shows that the cause is a blockage in the sprinkler gearbox. This blockage of the gearwheels can be caused by deposits or fine sand, rust residues (ferrous water) or other solid particles (lime, suspended matter) in the water. You can clean the sprinkler insert under clear water and try it again. If this does not eliminate the fault, the sprinkler gearbox cannot be repaired and therefore only the complete sprinkler insert have to be replaced. Best regards from Ulm GARDENA Service
Amazing, i really enjoy this.
I was looking at the products very confused but the clears so much out.
Well done, i can tell there was effort put in here
We are very happy this video helped you! Have fun with your Sprinklersystem :)
Can I take out my sprinklers T200 before winter and leave just pipline in the ground? I have installed two drain valves but i am afraid that i would find broken sprinklers when spring comes..👍🏼 thanks!
Hello Gardena Fan,
By using the drainage valve at the lowest point, the complete system becomes frost-proof. The sprinklers do not have to be disassembled.
Best regards
GARDENA Service
Hi! It was very helpful.
ich habe eine grundsätzliche Frage:
wenn ich den Ventilbox einbaue, kann ich auf den Bewässerungscomputer GARDENA smart WaterControl verzichten?
Hallo Melih,
vielen Dank für Deine Nachfrage.
Wenn Du die Ventilbox mit Ventilen einbaust kannst Du auf den Bewässerungscomputer GARDENA smart Water Control verzichten.
Zur Ansteuerung der 24 Volt Ventile in der Ventilbox wird allerdings die GARDENA smart irrigation control benötigt.
Viele Grüße aus Ulm
GARDENA Service
Hi I want to install a decent / professional / pop up sprinkler system in my garden, that is connected to a timer. Do you know what I should do?
I just need to know,
1' how many sprinklers I need
2' what kind of sprinkler exactly is best
3' where to ideally locate the sprinklers
I have a picture s of my garden and the sizes of / dimensions if I emailed them to you could you advise me thanks
James Pitt I can help you
8 years late but what did you end up doing?
Hello! When i regulate water flow od sprinkler 140 does it affect on water consumption witch is 22?
Hello Gardena Fan,
thanks for your message.
For the OS 140, the consumption value of 22 must always be taken into calculation.
Best regards from Germany
GARDENA Service
GardenaWorldwide thanks! ❤️
GardenaWorldwide Can you help me also about rotating problem on sprinkler T200? How can i fix problem, it rotates for 10-20sec. and than stops.
Hello Gardena Fan,
we are pleased to help you.
Best regards from Ulm
GAERDNA Service
Hello Gardena Fan,
thank you for your question.
When a sprinkler no longer rotates and remains in place, experience shows that the cause is a blockage in the sprinkler gearbox. This blockage of the gearwheels can be caused by deposits or fine sand, rust residues (ferrous water) or other solid particles (lime, suspended matter) in the water.
You can clean the sprinkler insert under clear water and try it again. If this does not eliminate the fault, the sprinkler gearbox cannot be repaired and therefore only the complete sprinkler insert have to be replaced.
Best regards from Ulm
GARDENA Service
Why do sometimes my t200mand t380 not turn?
Please reach out to our service: service@gardena.com
Our colleagues are happy to help you.
Best regards from the GARDENA Team.
Can I install a system in the United States?
You can, but this video is 10 years old lol😅 they have made smart ones now.
I love Grass love
YES
Hi
Hi
YES