Ceramicspeed OSPW Installation on Sram Red AXS

Поделиться
HTML-код
  • Опубликовано: 16 окт 2024
  • Installing a Ceramicspeed Oversized Pulley Wheel OSPW onto a Sram AXS Rear derailleur. This is part of my 2023 S-Works Tarmac SL7 project. #cycling #cyclinglife #roadbike

Комментарии • 17

  • @jakesiney
    @jakesiney Месяц назад +1

    Did the high setting workout ok? just fitted the same on low and the chain is bouncing around like mad.

  • @mlee6050
    @mlee6050 Год назад +1

    I wanted to check does the fluid clutch stay on body of rear derailleur? I am just unsure how it works as looks like take cage off and it takes clutch

    • @MitchOnTwoWheels
      @MitchOnTwoWheels  Год назад +1

      The spring is the clutch. It comes off briefly, then goes back in with the new cage.

    • @mlee6050
      @mlee6050 Год назад

      @@MitchOnTwoWheels okay thanks, wanted to check as felt worried about what happens to what they said was orbital fluid clutch or something
      can't wait to make my next bike that will have it on, going over the top on stuff even if use as daily too so trek Emonda alr that be lighter than a trek Emonda SL7 and cheaper, want long lasting and aero, only carbon be forks and what on groupset, all else trying to avoid it so know last long time

  • @marcelomarques533
    @marcelomarques533 Год назад +1

    please can you tell me which is the difference from these products labeled as "alternative" to the other not labeled as alternative?

    • @MitchOnTwoWheels
      @MitchOnTwoWheels  Год назад

      I’m not sure? Maybe gear capacity for bigger cog size?

    • @ricksvic6062
      @ricksvic6062 6 месяцев назад

      Alternative parts fit into the existing cage I believe.

  • @kertamuktibike4616
    @kertamuktibike4616 8 месяцев назад +1

    what is the name of the tool?

  • @chrispictures1
    @chrispictures1 4 месяца назад +1

    Yeh right, the record button wasn't working,,, a bitof a shambles

  • @leedorney
    @leedorney 10 месяцев назад +3

    The critical reason I started watching, you didnt show... 🤦‍♂️

  • @vanhelmen3168
    @vanhelmen3168 4 месяца назад +1

    Thanks for the video but leaving out the critical parts doesn't help us at all.

  • @chrispictures1
    @chrispictures1 4 месяца назад +1

    I can guarantee that that is made for approx 10-20$ and it has been proved by cycle engineering to have no benefit whatsoever,, and as an engineer just because something runs very free doesnt make it faster,, usually the opposite... the original was much better and well greased allows free running under pressure, loose spinning osps cause friction nder pressure

    • @MitchOnTwoWheels
      @MitchOnTwoWheels  4 месяца назад

      There's quite a bit of testing literature that says otherwise... Albeit marginal, it does make a difference.