I’ll still be amazed if those screws lineup properly with the holes you should just screwed them right through the holes. And I don’t know why they don’t use just hex bolts instead of screws that will probably get stripped
One comment, when drilling any hole in a boat, especially the floor, you should always use a drill stop. I just repaired a 1/4 inch hole that the previous owner punched all the way through the hull when he installed a new seat. He couldn't figure out where all the water was coming from.
Should you not have a back plate underneath? Those screws will just pull straight out in choppy water.
What type of glue/caulking is that?
What size of screw to install pedestal ?
I’ll still be amazed if those screws lineup properly with the holes you should just screwed them right through the holes. And I don’t know why they don’t use just hex bolts instead of screws that will probably get stripped
I would love a chair like this but just higher
One comment, when drilling any hole in a boat, especially the floor, you should always use a drill stop. I just repaired a 1/4 inch hole that the previous owner punched all the way through the hull when he installed a new seat. He couldn't figure out where all the water was coming from.
Should add silicone to screw before it was driven in to stop the water coming in from the top too.
Is it true these boat don't have stringers
buenas noches como lo compro por colombia gracias