HP LaserJet P2015 Fatal error fixed ||Toner and Paper JAM lights solid on ||

‪@PrinterSurgeon‬ welcomes you to watch a new video about HP LaserJet p2015 fatal error
In current video hp laserjet p2015 turns on and after panel lights blinking step by step paper jam and toner lights become solid on.
By pressing of button to check secondary there is no indication, even printer doesn't respond when front cover is opened and closed. seems to be printer is stuck/hanged.
#hp
#hprepair
#printer
#printerfixtips
#printerrepair
#printerrepairingcourse
#how
#howto
#howtorepair
#hpprinter
#hpprinterservice
#hpprinters
#tutorial
#tutorials
#fixprinter

[@MUHAMMADRAFIMUJAHID]

انتہائی سادہ زبان میں' اَتَم مہارت کے ساتھ دیا گیا visual ٹیوٹوریل ! جزاک اللہ خیراً

[@zarzarel1910]

میں نے دوسری ویڈیوز دیکھی ہیں جہاں فارمیٹر بورڈ کو الیکٹرک اوون میں ڈالا جاتا ہے اور 375 ڈگری فارن ہائیٹ پر 8 منٹ تک رکھا جاتا ہے اور فارمیٹر بورڈ کا مسئلہ حل ہو جاتا ہے۔
یا دوسرے لوگوں نے ہاٹ ایئر اسٹیشن کے بلور کا استعمال کیا اور بورڈ کے مرکزی چہرے کی سطح کو گرم کیا۔
اگر میرے پاس تبدیلی کے لیے فارمیٹنگ بورڈ نہیں ہے، تو آپ کون سا حل طریقہ تجویز کرتے ہیں؟
ویڈیو کے لیے شکریہ

[@PrinterSurgeon]

In some cases if the formatter processor is not working properly and was over heated and lost it's soldered bubble contacts you can do this risky experiment if you have knowledge of electronics.
But If you are sure the problem is with processor proper method is to remove the processor using SMD Rework Station and re-solder is using SMD Rework station.
I tried this method without consulting any video or senior. But success ration was only 10-20%. But you can do this experiment if you don't have alternative formatter board.
But I suggest, use thinner on board and wash it well using a paint brush or old tooth brush and wash its rust and dust thoroughly and put it in shining sunlight to become dry. Then check it. If it doesn't work then you can do experiment.

[@zarzarel1910]

@@PrinterSurgeon Thank you for the answer and for the precious helpful information... I will try to use the blower of a station at a temperature of 250 degrees Celsius, after you clean the plate of the former with isopropyl alcohol and a brush... all I have left is medicinal alcohol, but this it is not suitable for smd contacts... if I don't succeed, I will buy some chicken eggs and make an omelette with the pieces of the formatter board... good health and beautiful days ahead

[@PrinterSurgeon]

@@zarzarel1910 🤤🤣