Soft-starter( Siemens 3rw4047-1bb14 ) start-stop using push buttons. In Malayalam.

In this video, I am explaining how to start-stop a soft-starter ( Siemens 3rw4047-1bb14 ) using push buttons.
പുഷ് ബട്ടണുകൾ ഉപയോഗിച്ച് സോഫ്റ്റ് സ്റ്റാർട്ടർ (സീമെൻസ് 3rw4047-1bb14) എങ്ങനെ സ്റ്റാർട്ട്-സ്റ്റോപ്പ് ചെയ്യാം എന്ന് ഈ വീഡിയോയിൽ ഞാൻ വിശദീകരിക്കുന്നു.
#softstarter
#siemens3rw40471bb14
#startstopcontrolwiring
#eazyelectromalayalam
Queries solved:
1.how to wire soft-starter using push button.
2. explaning reset mode of the soft starter
...............................................................................................................................................
Warning!!!
This video is for educational purposes only. Electricity is dangerous and can cause personal injury or DEATH as well as other property loss or damage if not used or constructed properly. I am a professional in my work. DO NOT ATTEMPT ANY WIRING OF ANY KIND if you lack the knowledge and understanding required.

[@kishores2525]

good

[@sudarsanaakila2437]

No more any program settings?

[@muralimurali-in3cb]

Hi sir ln put voltage 380 but out voltage not working correctly what reason tell me

[@yohannesaraya5160]

Hii ,,, please some one can tell me what is the use of 13&14 NO soft starter

[@robertomuhammad35]

Hi
Can work with single phase 220v ?
Which model please

[@sudarsanaakila2437]

Why 1 Minuit run after failure

[@Saneeshpainakkil]

When starting motor with this it is taking more current than normal star delta starter. Why it is so?

[@EazyElectroMalayalam]

increasing the ramp-up time as well as setting a lower starting voltage can reduce the starting current. Also in this kind of soft starter, only 2 phases are controlled by SCR. So there is an asymmetry in starting current that may be the reason why you are getting high current than star-delta

[@anthonykazungu9134]

Translation

[@shameemma2121]

Hi bro... If we don't loop through NC of overload - it will still trip right? Then why do we need to loop

[@EazyElectroMalayalam]

Bro..I think you are right. Actually here we are using this NC control to actuate another relay so that if any overload failure occurs we will have a feedback signal in the control room.

[@yours4me1]

Hi brother, before soft starter need any breakers

[@EazyElectroMalayalam]

Yes of course

[@robertomuhammad35]

Dear can i get your mail for support plan ?

[@dangilumbaram1086]

Please speak hindi bhasa