The leaks tend to come from the seal installation depth or the collar installation depth. If it's non-abs the seal needs to be installed flush with the housing face and the collar sits against the bearing, if it's an abs type it very important the collar for the seal is installed to the correct depth on the axle (122.2mm from the wheel mounting face) Also, sometimes, if the old collar has been cut off the axle and a cut mark has been made on the axle journal the oil can travel under the collar and leak, usually a new axle or lots of loctite under the collar is required
Yeah LOL, fair comment, the press is a bit of a luxury. you can cut the collar off with a grinder and chisel without the press and knock the bearing off the axle, but the use of the press is best if you have access to one. 👍
Hi, I work at the Caterpillar dealership so all the Cat / snap on gear I get from the dealership (the public can also buy from Cat dealers) but honestly everything I use in these videos can be bought from a tool shop, auto shop and bunnings (ryobi stuff especially) it's all generic auto tools for my DIY jobs.
Good old ozzy no nonsense video. Well done.
Mate nothing get to about the bearing tool. Thinking outside the box 👌
I love Australians. Thanks for ya help
Great video, thanks
Hola tengo el problema con ese reten ya 3 Veces lo han avierto puse todo nuevo original y sigue la fuga ahora me dicen q compre un eje nuevo
The leaks tend to come from the seal installation depth or the collar installation depth.
If it's non-abs the seal needs to be installed flush with the housing face and the collar sits against the bearing,
if it's an abs type it very important the collar for the seal is installed to the correct depth on the axle (122.2mm from the wheel mounting face)
Also, sometimes, if the old collar has been cut off the axle and a cut mark has been made on the axle journal the oil can travel under the collar and leak, usually a new axle or lots of loctite under the collar is required
So a hydralic press is a basic tool 😂
Yeah LOL, fair comment, the press is a bit of a luxury. you can cut the collar off with a grinder and chisel without the press and knock the bearing off the axle, but the use of the press is best if you have access to one. 👍
Where did you buy the tools?
Hi, I work at the Caterpillar dealership so all the Cat / snap on gear I get from the dealership (the public can also buy from Cat dealers) but honestly everything I use in these videos can be bought from a tool shop, auto shop and bunnings (ryobi stuff especially) it's all generic auto tools for my DIY jobs.
عند صوت فلكاردا معرفتش لمشاكل اين بصبط