Geat but a few issues to fix first. My order arrived with an Australia mains cable which had the wall plug cable angled up not down! No problems these things happen... The final assemply department also incorrectly wired the mains Active and Neutral reversed from the back of the IEC panel mount connector. The error I uncovered was the output of the IEC fuse was not looped to the switch below, but was connected directly to the PSU with the black Neutral wire looped through the switch. Our local electrical safety regulator would have rejected this configuration. It took about 30 minites to rewire all the connectlions correctly i.e. the fuse outlet directly to the switch. I also needed to sperate out the mains 240V AC wiring from the 24VDC wires! It is unacceptable and poor practice to strap the single insulated mains wiring with the 24V DC wiring. I also check the soldering iron tip earth, the mains earth is soldered to the main control board with a lighter gauge than I was expecting (less than 1 -1.5mm2), with a very small 4.7ohm 0.125W resistor connecting to the PCB ground and iron tip. This practise is non-conforming and needs to be fixed. Otherwise the feature packed unit works extramely well so far.
Geat but a few issues to fix first. My order arrived with an Australia mains cable which had the wall plug cable angled up not down! No problems these things happen... The final assemply department also incorrectly wired the mains Active and Neutral reversed from the back of the IEC panel mount connector. The error I uncovered was the output of the IEC fuse was not looped to the switch below, but was connected directly to the PSU with the black Neutral wire looped through the switch. Our local electrical safety regulator would have rejected this configuration. It took about 30 minites to rewire all the connectlions correctly i.e. the fuse outlet directly to the switch. I also needed to sperate out the mains 240V AC wiring from the 24VDC wires! It is unacceptable and poor practice to strap the single insulated mains wiring with the 24V DC wiring. I also check the soldering iron tip earth, the mains earth is soldered to the main control board with a lighter gauge than I was expecting (less than 1 -1.5mm2), with a very small 4.7ohm 0.125W resistor connecting to the PCB ground and iron tip. This practise is non-conforming and needs to be fixed. Otherwise the feature packed unit works extramely well so far.
Link for full set of handles and tips? 3 handles + 9 tips?
Procesador ??
What wood is it compatible with? and how many watts of power