The only thing missing on this video is a "PARTS LIST" showing all of the filter part numbers. Being that the hydraulic filters are two different part numbers this would have helped. Otherwise, this was simple and straight to the point.
Great video. I see you ran an accessory power supply toward the rear of the tractor. I’d like to do the same for some ROPS lights. Can you describe or show the routing you used? My amp draw is too high to use the factory harness taps.
@@machinemonster3527 Ah. Now I understand. I have front remotes also but had the dealer add the “factory” setup and it got tied into the existing harness. Looking down both sides of the tractor there isn’t a really clean way to the rear. Thanks for your reply. Best of luck with your machine.
Very helpful video thanks
You're welcome!
Nice job
Thanks!
The only thing missing on this video is a "PARTS LIST" showing all of the filter part numbers.
Being that the hydraulic filters are two different part numbers this would have helped.
Otherwise, this was simple and straight to the point.
Thank you for letting me know. My videos from here on out I can add that to it!
Great video. I see you ran an accessory power supply toward the rear of the tractor. I’d like to do the same for some ROPS lights. Can you describe or show the routing you used? My amp draw is too high to use the factory harness taps.
Thank you! Are you talking the power for my front remotes to the bucket?
@@machinemonster3527 Ah. Now I understand. I have front remotes also but had the dealer add the “factory” setup and it got tied into the existing harness. Looking down both sides of the tractor there isn’t a really clean way to the rear. Thanks for your reply. Best of luck with your machine.
I did that oil fill down low on my 3010 only to realize after there was a fill cap on very top of engine is there one on these newer kubotas?
That's a good question. I'll check when I get home. I think the manual said fill in the dipstick hole, but on double check.
were your hydro filters tough to take off?
No not to bad at all.
What type of hydraulic fluid does it use and is it the same as the trans fluid?
It is kubota UDT fluid and yes hydraulic and transmission.