Hello my friend, I don't know if you gonna read my comment, but I wanna thank you a lot, you saved me inverting the positions to normal. My Atomstack A5 PRO been reading de x and y in negative numbers. You fixed my problem showing me the menu with the coordinates. Kiss n love from Romania and good luck!
1. Open the light burn link to the machine, then find Machine Settings in Edit in the upper left corner and open the machine settings; 2. After opening, find the settings of {Hard Limits ($21)} and {Homing cycle$22} and change False to True.
I put the switches at the bottom right on sculpfun s9 I modified using glbr and laserburn and now it does the home at the bottom right, but if I start it it slams against the switch Y as if it were upside down, I tried to engrave manually and it results on the contrary (but not mirrored) how can I do??? Thank you
Hello, ERR20 means unsupported command, an unsupported or invalid g-code command was found in the block 1. It may be that the format of your engraving file is incorrect, or the main board cannot recognize the G code command issued by the computer, you can try to refresh the firmware of the machine, or replace other pictures or engraving files
Buenas colega a mí me sale ese error. ALARM:1 Límite duro activado. Es probable que la posición de la máquina se pierda debido a una parada repentina e inmediata. Se recomienda encarecidamente el inicio. En o cerca Tengo una atomstack maker 10 v2
Hello my friend, I don't know if you gonna read my comment, but I wanna thank you a lot, you saved me inverting the positions to normal. My Atomstack A5 PRO been reading de x and y in negative numbers. You fixed my problem showing me the menu with the coordinates. Kiss n love from Romania and good luck!
Love these videos, they go so fast you can follow what they’re doing. No explanation no nothing think this is just to piss us off more.
terribly sorry,
I don't know how to edit, so I didn't add subtitles.
1. Open the light burn link to the machine, then find Machine Settings in Edit in the upper left corner and open the machine settings;
2. After opening, find the settings of {Hard Limits ($21)} and {Homing cycle$22} and change False to True.
I put the switches at the bottom right on sculpfun s9 I modified using glbr and laserburn and now it does the home at the bottom right, but if I start it it slams against the switch Y as if it were upside down, I tried to engrave manually and it results on the contrary (but not mirrored) how can I do??? Thank you
What is the point of this post. Cannot read the screen and no audio!
You go way too slow and you need to turn your voice down!
Error20
Hello,
ERR20 means
unsupported command, an unsupported or invalid g-code command was found in the block
1. It may be that the format of your engraving file is incorrect, or the main board cannot recognize the G code command issued by the computer, you can try to refresh the firmware of the machine, or replace other pictures or engraving files
Buenas colega a mí me sale ese error.
ALARM:1 Límite duro activado. Es probable que la posición de la máquina se pierda debido a una parada repentina e inmediata. Se recomienda encarecidamente el inicio. En o cerca
Tengo una atomstack maker 10 v2