My high flow probe does not clear all the way and it is align like you said. WHAT SHOULD I DO? Align the probe looking at the hole or make the probe flush. I install a .22 cal liner with the dual port from huma and with 150 bars with the 34 grain slugs I couldn't get to 950fps which is weird because this gun with the .30 cal barrel do 1000fps with 140 to 145 bars in the rear reg with 44 grain jsb.
Your barrel is sitting too deep if you can't get a mag in. Take out your barrel, put in the mag, and reseat your barrel. Test your magazine movement and tighten. You should be good to go.
@@nategoodwin3329 thanks, that was exactly the issue. But I created a bigger issue. I found the bolt that tightens the barrel and set it right. That particular bolt doesn’t have a wider head so I kept tightening it until it damaged the bullet probe underneath it, now I have to replace it.
I just had this problem last week and UA helped me get my timing correct! Thanks again👍
Glad we were able to help!
I saw the "timing" title and thought of the old days of tuning the WGP Autococker paintball "markers" :)
Ok, what he didn't mention or maybe I didn't catch it. Blue lock tite will be needed to prevent screws from loosening again.
Ace Guys... Ace
Thanks for the helpful hints guys 👍🤠🇦🇺
Could you show how to do this on a Mke 1 wildcat please power is down and it’s nibbling the hammer
My high flow probe does not clear all the way and it is align like you said. WHAT SHOULD I DO? Align the probe looking at the hole or make the probe flush. I install a .22 cal liner with the dual port from huma and with 150 bars with the 34 grain slugs I couldn't get to 950fps which is weird because this gun with the .30 cal barrel do 1000fps with 140 to 145 bars in the rear reg with 44 grain jsb.
Mk1 Fx Wildcat .25 cal. How to tune the brass inlet? Mine stops the mag from getting to place
Your barrel is sitting too deep if you can't get a mag in. Take out your barrel, put in the mag, and reseat your barrel. Test your magazine movement and tighten. You should be good to go.
@@nategoodwin3329 thanks, that was exactly the issue. But I created a bigger issue. I found the bolt that tightens the barrel and set it right. That particular bolt doesn’t have a wider head so I kept tightening it until it damaged the bullet probe underneath it, now I have to replace it.