#Nut_and_Bolt_design If you like our video, do subscribe and smash that like button. You can comment your doubt in a comment section for clarity. Thank you.
Dear brother, While thanking you for the explanation I would like to point out about a small technical error. When creating the bolt, the helix should union with it and should not subtract. Otherwise the bolt will pass through the nut without any revolve.
Very nice but instead of the circle being the profile of your sweep, can you do this with a triangle for a more realistic looking thread?
Very straight forward, thank you somuch!
Really helpful. Thank you very much for such content.
Thank you Sir, is really helpful.
The Best Vedio I ever Found To Understand ❤
Really helpful. Thank you very much for such Bro......
Thanks so much.I'm a beginner,and I see it very good
Dear brother,
While thanking you for the explanation I would like to point out about a small technical error. When creating the bolt, the helix should union with it and should not subtract. Otherwise the bolt will pass through the nut without any revolve.
Thanks for uploading such content.
It was really helpful.
Keep going! Amazing video. 🔥
You are welcome mitra😍and thanks for encouraging words🤗🤣
Great Sir
Hello Frands😂😂
Ramro xa hai video. Keep it up...
I'm thankful for your words frands🤗🤣
thank you so much sir!!!!!!!!! YOU'RE THE BEST! SHEEEEEEESH
Cool
Thanks bro😍
Great
Useful
👌👌👌👌🙏🏻🙏🏻🙏🏻🙏🏻
Nicr
Thanks
Everything is fine but when I was doing the helix at 6:22 minutes, instead of going down, the helix goes up after I type 30, what should I do?
Use - if thread going wrong side or use cursor for up or down
Sir unable to sweep bol rha hai
Now how you convert it to pdf with the point of views?
Use plot