Thank you for the comment, The controller for G-650 has a 450 degree rotation angle where as the KR-400 rotator only has 365 degrees of rotation angle, you will have a hard time aligning the two. Also KR400 rotators do not have the motor start CAP inside them, where as the G-650 rotator does have the motor start CAP onboard because they have limit switches. You would have to install a motor start CAP to the KR-400 rotator or add it to the G650A controller, which will make it not work properly if you use it with a G650 rotator again. Regards Peter of Duoro
Can I use a Yaesu GA-650 rotator control and pair it with a Kenpro KR400 motor
Thank you for the comment, The controller for G-650 has a 450 degree rotation angle where as the KR-400 rotator only has 365 degrees of rotation angle, you will have a hard time aligning the two. Also KR400 rotators do not have the motor start CAP inside them, where as the G-650 rotator does have the motor start CAP onboard because they have limit switches. You would have to install a motor start CAP to the KR-400 rotator or add it to the G650A controller, which will make it not work properly if you use it with a G650 rotator again. Regards Peter of Duoro
@@duoro-rotators ok