I’m surprised they didn’t make some sort of sleeve for the rear center tray/cupholder. What was the hardest part? Seemed like those side bolsters in the rear were annoying.
I think other than a full replacement, I don’t know if they could make the recess part where the armrest goes look decent. It’s no way to make that area tight. I think their solution was decent, even though I don’t love it. And no part of the install was hard. The hardest part was removing the bottom rear seat. It’s a little time consuming doing the final adjustments, so patience is needed for a tight fit and good results.
Been subscribed for awhile can’t wait to do this to my Mazda 6
It changes the whole feel of the car! And thank you for supporting the channel!
I’m surprised they didn’t make some sort of sleeve for the rear center tray/cupholder.
What was the hardest part? Seemed like those side bolsters in the rear were annoying.
I think other than a full replacement, I don’t know if they could make the recess part where the armrest goes look decent. It’s no way to make that area tight. I think their solution was decent, even though I don’t love it.
And no part of the install was hard. The hardest part was removing the bottom rear seat. It’s a little time consuming doing the final adjustments, so patience is needed for a tight fit and good results.
How are they holding up ?
The EKR seat covers are holding up perfectly between me, my two kids and my wife. I am about to order a set for my 2007 Yukon!
I have a 2021 wagon but im scared of ordering online and finding they wont fit my model
You have a mazda 6 estate? If so, I am not sure of the backseat is the same as the sedan
Hello
Hi
Martin Thomas Martinez Ruth Wilson Steven
💪🏽