Squarebody NP208 Transfer Case full rebuild with 32 spline input shaft

[@joeybartsch2252]

This is exactly what I was looking for being I'm due for a rebuild myself! What a great resource, nice work!

[@vikingmech]

@joeybartsch2252 Thats great, hope this helps you out. Thanks for watching and commenting!

[@briantroglin1831]

Great video brother. Thank you for posting.

[@vikingmech]

@briantroglin1831 No problem, hope it was useful. Thanks for watching and commenting!

[@juanquiroz4948]

Great video what part number is that 32 spline input shaft you used i am looking on doing the same on my np208

[@liebherrman1628]

There is a o-ring on shift shaft and a retainer easy to get to when apart

[@gearboxgarage]

You needed a new Annulus Bushing (2.775” OD) (NP208-62), this was bad and is why you had slop in the planetary.

[@vikingmech]

Good to know, thanks for adding this comment. If I feel any vibrations from the transfer case now I'll have an idea what to look into. Thanks!

[@tsimshian886]

Where did you put the new thrust bearing at 14:49?

[@vikingmech]

@tsimshian886 It goes on the back of the front output shaft. You can see it at 3:50 in the video. On the right hand side.

[@jd8230]

What output shaft for the prop shaft seal is that. It looks like one from a NP241

[@vikingmech]

@jd8230 I found that seal on amazon. GM Genuine Parts 15661460 Transfer Case Rear Output Shaft Seal