I'm going to amputee and I can't walk what do I do with all this extra stuff you have to do if I can't stand and I don't have nobody I'm by myself what do I do especially if I'm outside and there's nobody around what do I do just sit in the chair until somebody comes along there's too many things that can go wrong with a chair I'm supposed to be getting a chair in about 2 to 3 weeks I already had to send it back because they didn't measure my door correctly or the seat correctly or the color correctly that seemed before I get to sit in it I don't know if I want the power chair I might just end up with my manual chair it's hard to maneuver but I think it's going to be better than a power chair thank you
The power chair gives you more mobility but the manual chair won't break down you gotta decide what is best for you I have been stranded in my power chair several times it sucks
Could be low voltage. I would say have your batteries checked at a auto store. They can put it on a machine and see what the voltage is as well as if the batteries are good.
I would look first into the charger. If no lights are coming on the charger, you may need to replace the charger with a new one. First I would make sure the outlet that you are using works (maybe plug a light into it to see if light turns on). If the outlet works and plugging the charger into it as well as the mobility unit and still no lights, possibly the charger. The charger should get warm after being plugged into the unit for an hour, it its warm, its working.
I have been getting a fault code little wrench and a little person when I am turning, a few days ago the chair turned on and for thirty minute blasted a beep noise. My wheelchair repair reset the chair but I am still getting a fault code.
Not sure what would be causing that. I would contact the manufacturer if I were in your shoes. They will be able to ask you some questions and hopefully get you an answer and resolution.
We do purchase power chairs from users depending on the make/model, age, condition and mileage. For that model we would pass. We have a couple that we still have and no room to store others. Thanks for thinking about us though.
You would have to have an ohm meter and set your test meter to the lowest OHMS scale. Verify that the brake is engaged. Insert the test leads into the top two terminals in the plug. You should be reading the resistance of the brake. It will be between 50 and 85 Ohms. If you dont have one, you can take it to a local mobility store and have them test it.
mine i can take it off charge and be from green to red and wont move before get back. Has brand new batteries. Can cut off for 10 minutes and will be full charged again. The cables going to joystick is getting hot. Wandering if loose connection or bad controller.
We would need to have more information than that in order to assist you. You can always give us a call or leave more information in the post where we would be able to assist in troubleshooting.
This was just a video showing what to do if the unit wont turn on. It seems as if you have power to the joystick, your unit is turned on. In order to help find a resolution, you could let us know what the issue you seem to be having so we can help find a resolution.
To be honest, quite a few people we speak with about troubleshooting something such as this has access to a volt meter, A few people do not but a lot of customers we speak with do. If we can answer any other questions, let us know. Hope that answers your question and have a great day!
I'm going to amputee and I can't walk what do I do with all this extra stuff you have to do if I can't stand and I don't have nobody I'm by myself what do I do especially if I'm outside and there's nobody around what do I do just sit in the chair until somebody comes along there's too many things that can go wrong with a chair I'm supposed to be getting a chair in about 2 to 3 weeks I already had to send it back because they didn't measure my door correctly or the seat correctly or the color correctly that seemed before I get to sit in it I don't know if I want the power chair I might just end up with my manual chair it's hard to maneuver but I think it's going to be better than a power chair thank you
The power chair gives you more mobility but the manual chair won't break down you gotta decide what is best for you I have been stranded in my power chair several times it sucks
My Quickie is showing a warning for a battery system, can you tell me why it won't move
Could be low voltage. I would say have your batteries checked at a auto store. They can put it on a machine and see what the voltage is as well as if the batteries are good.
Oh boy that seat isnt light lol once the seat disconnected i ate the dirt lmao thank goodness it wasnt my grandpa working on it
Thanks goodness it wasn't him and hope you're ok.
Want one!
If you plug charger up to it and no charger light comes on are the batteries dead or what?
I would look first into the charger. If no lights are coming on the charger, you may need to replace the charger with a new one. First I would make sure the outlet that you are using works (maybe plug a light into it to see if light turns on). If the outlet works and plugging the charger into it as well as the mobility unit and still no lights, possibly the charger. The charger should get warm after being plugged into the unit for an hour, it its warm, its working.
I have been getting a fault code little wrench and a little person when I am turning, a few days ago the chair turned on and for thirty minute blasted a beep noise. My wheelchair repair reset the chair but I am still getting a fault code.
Not sure what would be causing that. I would contact the manufacturer if I were in your shoes. They will be able to ask you some questions and hopefully get you an answer and resolution.
@@Marcsmobility it ended needing a computer to be replaced
How do u take a transformer from another chair and put and connect in another chair ?
You're not able to
How do I locate reset button on q6 edge 3 power wheel chair
You can look at the back right under the shrouds to find it. Hope this helps!
I bought one of these used, and the batteries are probably dead. One reads 11.8v and the other reads 15.2v I wonder why
Not sure. You should have power. I would advise you to reach out to a local mobility store and have them take a look at it for you.
😢I really want one!
We have them for sale. Give us a call at 800-677-6293 and we can get you one shipped out
Do u buy whell chairs. Quickie 700 m
We do purchase power chairs from users depending on the make/model, age, condition and mileage. For that model we would pass. We have a couple that we still have and no room to store others. Thanks for thinking about us though.
How to I check to see if one of my motors are getting voltage
You would have to have an ohm meter and set your test meter to the lowest OHMS scale. Verify that the brake is engaged. Insert the test leads into the top two terminals in the plug. You should be reading the resistance of the brake. It will be between 50 and 85 Ohms. If you dont have one, you can take it to a local mobility store and have them test it.
Just bought my p326d out of the box it’s not turning on
Did you purchase that Merits chair from us? Have you made sure the batteries are connected and the joystick cable is connected to the chair correctly?
mine i can take it off charge and be from green to red and wont move before get back. Has brand new batteries. Can cut off for 10 minutes and will be full charged again. The cables going to joystick is getting hot. Wandering if loose connection or bad controller.
You will need to get that unit into a mobility store and have someone take a look at it, something is not right on that unit.
Power chair is not turn on or not move at at
We would need to have more information than that in order to assist you. You can always give us a call or leave more information in the post where we would be able to assist in troubleshooting.
Myq chair won’t pull !
I'm sorry to hear that but we would need more information to assist you in a resolution.
kinda useless info without knowing what to do if you do have power to the joystick.....
This was just a video showing what to do if the unit wont turn on. It seems as if you have power to the joystick, your unit is turned on. In order to help find a resolution, you could let us know what the issue you seem to be having so we can help find a resolution.
What fn person that has a wheelchair has a meter and has the capability to do this…
To be honest, quite a few people we speak with about troubleshooting something such as this has access to a volt meter, A few people do not but a lot of customers we speak with do. If we can answer any other questions, let us know. Hope that answers your question and have a great day!
P