Aprilia RS 250 Two Stroke | Rebuilt Motor Dyno Test
HTML-код
- Опубликовано: 6 сен 2024
- We put a Aprilia RS 250 two stroke on our dyno to test after a recent motor rebuild.
To receive information about our dealership or please give us a call at (973) 751-4545 Ext 1, or email (Ian@MotorcycleMall.com) or visit us at 655 Washington Ave, Belleville, New Jersey.
Motorcycle Mall is the tri-state area's premier motorcycle and powersports dealership; a true destination dealership for any motorcycle or powersports enthusiast. We have new and used motorcycles, ATVs, dirt bikes, utility vehicles, water crafts, scooters, generators and snow blowers. Our Parts Department is one of the largest in the USA and our full service Service Department is staffed with manufacturer certified technicians for all of your needs!
Visit us at:
www.MotorcycleM...
Shop Online:
motorcyclemall......
Like Us & Follow Us On Facebook!
@MotorcycleMall
/ motorcyclemall
Follow Us On Instagram!
@MotorcycleMall
/ motorcyclemall
Also Visit Our eBay Store!
www.ebay.com/u...
MAKE SURE TO SUBSCRIBE!
Please Rate, comment, and share this video.
Finally, someone that actually knows how to dyno a 2 stroke.
Meh 1:27 to 1:45 engine braking is not what I consider a real operator
@@The_fappening my thoughts exactly. I’ve seen a cr500 lock up while on dyno due to this nonsense
@@The_fappening they got an oil pump so it is still getting lubricated, thats no problem for this bike
what’s the number ?
3:10 watch the pop!
At full RPM I was yelling clutch as it’s only the idle/pilot jet operational when you suddenly close the throttle.
If it's still running oil injection, the pump control cable is tied to the powervalve controller and the throttle so it keeps getting extra oil at high rpm (>8000) even off throttle. He was clutching/blipping it as it spun down too.
Brutal, solo quería decirte que me hubiera gustado mucho saber velocidad punta y revoluciones..... Ufff
Terbaik mantap hebat padu👍👍👍
3:08 those are some nice pops there
Thank you for the feed back, bike still needs some work to be done.
hp?
why post a dyne run with no data.
This was an older dyno run and its a great question - it should have had all of the details. We apologize about that and all of the newer dyno runs have the full details (only the older ones does not have them). If we can dig up that info, we'll get it posted.
What does this stuttering come from? To be seen at 2:53-3:00. Mine also has that in the 2nd course
It running lean my dude
She's a little rich I think!
Thx for the video..... tough it sounds like the setup of the carbs/ignition needs adjusting... it was stuttering bad a few times
Would love to get my hands on one of these but prices over here are getting ridiculous....
Well as it was mentioned in the discription the motor was just rebuilt and the bike was just being tested. The bike still needs to under go more work
Motorcycle Mall
I did not read the discription .... sry ...
Great bikes tho i hear they require a lot of maintenance to keep in good running order ...
@@TheMatrixcube Not a problem. Once the bike is finished we will have a full video of the dyno running on the dyno.
Powervalve setup will sort the stuttering, they’re not opening properly at the same time.
What was that at 1:17 when the rs started bouncing?! God😂 i thinked that it could implode😂 it was like if someone putted a banana in one of the silencers😂
the engine was not able to take the fuel
Maybe not warmed up enough?
Looks like the engine is cold 🙄
Lean at mid range imo
Say no to 2 stroke engine braking
Topspeed at Dyno ?
Sorry we don't know, we are just putting the bike on the dyno to test the rebuilt motor. Once completed we will have a full video dyno video
How much BHP ..??
Unfortunately we didn't put the bike on the Dyno to see what the top BHP was. Once the bike is back together we will have a full video dyno video with power figures
60hp ❓
Not sure yet we did not run the bike to see the power this time around. We will do another video of the bike on the dyno once its all finished up.