Это видео недоступно.
Сожалеем об этом.
V6 Engine ECU *almost* installed
HTML-код
- Опубликовано: 4 июл 2024
- I'm homing in on a fully installed electrical system - including the engine.
This requires a permanent fixing and so a bracket - which is not totally easy
Music: Happy Rock by Bensound
#motorsportelectronics #me360
#aj30 #Duratec #Rx8 #adaptor plate
#restomod
#classiccars
#fibreglass
#britishcar #madeinwales
#mazda #ford #jaguar
#RX8 #MX5 #s-type #stype #escort
#tightfit
#customexhaust #manifold #exhaust #exhaustmanifold
#rocketeer
#rwd
Ha ha very comical Speg, next time maybe you will make the bracket first, then mark all four rivnut holes in unison. Happy days mate.
I've just stumbled upon your channel. I'm seriously considering this engine swap for my TVR 3000M. I'll have to get stuck in and watch all you videos to get some learning and pit falls to avoid!
I've got a RX8 5 speed box which I've just got to go behind the Essex so might hold off and get an AJ30 to fit in front instead!
@@The_Cotswold_Cyclist thankyou. It has been a long haul although there has been loads more to do than just the engine.
I hope to get near a first fire up in the next couple of weeks!
@@Mr_Spegru it will be an epic car once done with that engine! The Rocketeer MX5 conversations look bonkers.
Do you have base map for the ECU for initial start up? Guess it'll need rolling road tuning after that?
@@The_Cotswold_Cyclist No i dont have a map per se but I semi know someone who is running the same setup. Also Motorsport Electronics promise to get you going. In the end though yes a rolling road likely required