How to install a solar tracker? the step by step installation guidance of ECO-WORTHY solar tracker
HTML-код
- Опубликовано: 23 авг 2024
- Our solar tracker seems to be complicated, but it's quite easy to be installed. Don't worry, in this video, we will show you step-by-step installation. you must learn how to do it. if you have any questions or difficulties, do not hesitate to contact us via info@eco-worthy.com
To buy one, here please: www.eco-worthy...
So, should I trust their equipment if they cannot produce correct how to videos?
The wind sensor is shown installed incorrectly. At 2:47 the video shows the wind sensor mounted in the NW corner, and the user manual page 4 clearly shows it should be NE corner (for northern hemisphere). Also, the controller is mounted sideways (due to hole location), but the user manual page 14, notice #4, says to mount with wires facing down (to prevent water intrusion around seals). Eco-Worthy should make these videos and documents correct and consistent.
at 0:43 the video shows the D bracket being installed on the west side. This is incorrect! I received information when doing my installation to assemble the D bracket and the long actuator this way and it caused the actuator to get bent and it seized up. I had to replace the actuator. The D bracket should be on the east side, and rotated 180 degrees, with the actuator facing west. If you turn it on in this configuration, when it goes flat, it'll bend the actuator and you can't stop it without an on/off switch. At 1:00, it shows improperly installing the channel. It needs to be reversed, so the actuator will point west.
Can you post a short clip of how you set yours up? I am currently running into the problem you’re describing I believe.