Question please, having both transducers that close to each other "Do you have any interference issues?" I have a new Bass Tracker and I am planning to mount two transducers on the rear, a Garmin GT24 for my Garmin 63cv and a GT54 for my Garmin 93sv. What are your thoughts, can I mount them as close as you have them to each other? Thanks for your time and GREAT Video!
You think j&b weld would hold without the screws? Also curious to know if you sand the block and the boat before applying the J&b weld on to the boat? Is it still holding up?
I did rough up both surfaces before the JB weld for sure. I used it on both blocks. One has the screws and one doesn’t they are both still running strong and we are on the water quite a bit
Interesting, we always screwed 3/4 s of the way into the transom with lots of marine grade silicone in the pilot hole and around the screw. J. b Weld looks like a good idea also on thru the transducer block.
Hi there great video. I have a transducer block and the screws that came with my 3 in 1 are too long. What size screws did you use? I have same transducer as you
I see your point. This is very much a lore permanent fixture. If you thought you would replace it at some point, I would screw the block to the transom. At least there would only be 2 holes?
Would've been pretty disappointing to have that happen, but glad to see you got 'er rock solid!
It is now, for sure. Disappointed with the damage but, not much we can do now. Hopefully, this saves others from having the same problem.
Question please, having both transducers that close to each other "Do you have any interference issues?" I have a new Bass Tracker and I am planning to mount two transducers on the rear, a Garmin GT24 for my Garmin 63cv and a GT54 for my Garmin 93sv. What are your thoughts, can I mount them as close as you have them to each other? Thanks for your time and GREAT Video!
As long as the 2 transducers are not running the same frequency, it should be just fine I would think.
You think j&b weld would hold without the screws? Also curious to know if you sand the block and the boat before applying the J&b weld on to the boat? Is it still holding up?
I did rough up both surfaces before the JB weld for sure. I used it on both blocks. One has the screws and one doesn’t they are both still running strong and we are on the water quite a bit
@@castforeffect3359 awesome thanks. Great video 👍
Interesting, we always screwed 3/4 s of the way into the transom with lots of marine grade silicone in the pilot hole and around the screw. J. b Weld looks like a good idea also on thru the transducer block.
Hi there great video. I have a transducer block and the screws that came with my 3 in 1 are too long. What size screws did you use? I have same transducer as you
3/4 to get the transducer into the block
What will you do should you want to remove/replace the plate?
I see your point. This is very much a lore permanent fixture. If you thought you would replace it at some point, I would screw the block to the transom. At least there would only be 2 holes?
Do you get interference? With the do different graphs?
Not that I notice at all