@@Diamondsintherubble handheld map gas torch. Something bigger could have worked. I think it was also 1/8" aluminum, so thinner would have been better.
@@RinerAutomotive well all the aluminum piping is 1/16” thick, I’m going to drill 2 holes and lock the fittings in with the alumiweld. Oem hose was a single 1” and I ended up with dual 1/2”. I plan on getting a big boy bernzomatic. Idk if I should go butane or propane but I’m looking at a $30-$50 range for full setup
I actually want to silicone hose from the lower nipple to the tank nipple. The tank has 6 fitting/threaded holes, 3 on each side so I have lots of options to mess with. I’d like to get a same diameter or close nipple barb for the tank so there isn’t a lot of reduction between the ends
I’ve been dying to know who Turruviate is. Thanks for the plug Alex.
Im with you ,real hands on work , keep going
Better be making a video on that manifold! We need it!
Looking like a young Christopher Walken bruh
I’m tryna look like uuuhhhhh beetle juice uuuhhhhh yeah 🤣
Good shit
I tried the Alumaweld rods before, it was tough getting enough heat into the aluminum for a good weld. setup looking good.
Did you use a blowtorch or a heat gun? My plan is to preheat with a blowtorch and maybe file a little slag off the top
@@Diamondsintherubble handheld map gas torch. Something bigger could have worked. I think it was also 1/8" aluminum, so thinner would have been better.
@@RinerAutomotive well all the aluminum piping is 1/16” thick, I’m going to drill 2 holes and lock the fittings in with the alumiweld. Oem hose was a single 1” and I ended up with dual 1/2”. I plan on getting a big boy bernzomatic. Idk if I should go butane or propane but I’m looking at a $30-$50 range for full setup
Best video’s ever . Keep them coming. 👍
Can you do a Colab build with Alejandro Flores 🔥🔥🔥
I wish but I gotta do one thing at a time
Best videos ever keep them coming
Damn my boy running a v mounted rad like a rx7
Looking good. Depending how thick that radiator tank is, you may be able to just drill and tap for the overflow fitting.
I actually want to silicone hose from the lower nipple to the tank nipple. The tank has 6 fitting/threaded holes, 3 on each side so I have lots of options to mess with. I’d like to get a same diameter or close nipple barb for the tank so there isn’t a lot of reduction between the ends
good work king 👑
Just ordered a whole bunch of crap, hopefully new vid next week 💪🏻
Lookin good buddy boy
Keep it up with the vids big dawg!!!
Comment for the community