For the single setup i had problems with the rubber and the spring,but ended up using a roll pin that i glued into the end of the set screw.your length may vary but it never gets stuck and has worked for 6 months
I can decap twice as fast as you with no ejector and with a short arm used with 2 fingers! And sort cases at the same time in front of me and dump deprimed cases in a bucket on the floor next to the ram with half the effort.
Thanks for your comments. No, I am not really setup to fabricate copies, but it was not too hard honestly. You can get the bushings from Tractor Supply Warehouse for somewhere in the $3 - $4 range, then the set screws for around $2. I wish I had an easy way to make a bunch of these, but alas, it is not in the stars. Thanks again!
I learned one thing with this press when doin black powder 38spec or 357mag for fun, NO RUSH! SLOW means no errors, blin!
Very innovative. Looks like a real time saver.
For the single setup i had problems with the rubber and the spring,but ended up using a roll pin that i glued into the end of the set screw.your length may vary but it never gets stuck and has worked for 6 months
Thank you the tutorial…hoping I can make work on the New Value press (2018)…again thank you from Montana
Thanks for sharing . Great idea. :-)
I lowered the the turret by 11/2 inches. This made the Handle stroke less then half the distance.
Very nice mod!
Have basically the same set up, but without the roller handle. Want to ask how you like the roller handle with the bends on the rod?
very educational
My safety prime does not operate remotely as smooth as yours, any suggestions to increase reliability?
I can decap twice as fast as you with no ejector and with a short arm used with 2 fingers! And sort cases at the same time in front of me and dump deprimed cases in a bucket on the floor next to the ram with half the effort.
I agree. This is alot for nothing.
Wow that is the best setup ,you are a genius !!! Just subscribed !! Question are you going to fabricate any copies ?
Thanks for your comments. No, I am not really setup to fabricate copies, but it was not too hard honestly. You can get the bushings from Tractor Supply Warehouse for somewhere in the $3 - $4 range, then the set screws for around $2. I wish I had an easy way to make a bunch of these, but alas, it is not in the stars.
Thanks again!
Could you please tell me what size the bushings are? Thank you
Dove si puo comprare quel binario che porta il bossolo finito nella vaschetta rossa?
Grazie
Awesome..
Would you make another and sell it to me?
where can I buy it?
I know this is an old video and the first time I've seen this but where do you get reversed rod?
Inline Fabrication.Com
he literally says it in the video like a couple of seconds before he says its a reversed rod