Apollo XP95/Discovery System Test #8!

In this video I test the new Discovery optical (Address 4), XP95 call point (address 1) and intelligent call point (address 10).
The next system test should have new devices such as a discovery sounder beacon base (address 5), another discovery sounder base (address 7) and a soteria heat detector (address 8).
Thanks for watching, see you guys in the next test!
Timestamps:
0:00 Intro & system changes
4:15 Smoke detector test
4:57 Intelligent call point test
6:20 XP95 call point test
7:55 Yapping & system plans
10:47 Outro

[@The_FireAlarmGuy]

Nice system mate 😊

[@obsirensandalarms]

@@The_FireAlarmGuy Thank you man!

[@j1firesystems440]

Good test!

[@obsirensandalarms]

@@j1firesystems440 Thank you so much!

[@dtcapture]

Nice job on the conduit install, would you be able to make a video on how your sheds electrical infrastructure is constructed?

[@obsirensandalarms]

@@dtcapture Thanks! And yeah I’ll do a showcase on my conduit run and how I done it.

[@Fire_Alarm_And_Safety_AU]

One Question, do you need a Control Panel for Connect to your Manual Call Point to another device?

[@obsirensandalarms]

@@Fire_Alarm_And_Safety_AU Apollo discovery is an addressable protocol which needs to be ran on an addressable panel. The panel I am using is an Advanced Electronics MX4100.

[@-RFS-]

Nice test next time try out a different tone

[@obsirensandalarms]

@@-RFS- I would but this sounder base doesn’t like to change tone for some reason so I’d have to use the config tool

[@-RFS-]

@@obsirensandalarms oh right I see

[@obsirensandalarms]

@@-RFS-your discovery base sounder that I bought off you works fine on a different tone