Parker Single-Acting Telescopic Cylinder Reseal Procedure

"How To" Series by Hydraulic Cylinders Inc. In this video you will learn the procedure and tools required to reseal a single stage of your Parker Single-Acting Telescopic Cylinder.
Hydraulic Cylinders Inc. offers Premium Aftermarket Seal Kits for Commercial/Parker cylinders including Series S53, S62, S63, S64, S73, S74, S84, S85, S95 and more.
Repacking Kits: www.hydraulicc...
Rebuild Kits: www.hydraulicc...
The hydraulic cylinder repair tools used in this video can be purchased on our website here:
www.hydraulicc...
Hydraulic Cylinders Inc. also offers a wide variety of new Replacement Parker telescopic cylinders. These cylinders are available here: www.hydraulicc...

[@Brad-lt6mr]

That thing with the masking tape is gold.

[@elliotkane4443]

That trick with the tape was really good, I wonder how well it works on an actually used & absued cylinder though.

[@damianfediuk2087]

Excellent video! I have a telescopic simple two stage cilinder and the second stage always gets down, no external leaking. Thanks for your comments.

[@jaypatel4727]

Thank you
It's very helpful to understand how telescopic cylinder is looks like inside

[@pedropinto813]

Cilindro hidráulico de doble efecto favor mostrar desarmado

[@virgilioperdomo4713]

Especial destreza en la reparación de un cilindro hidráulicos, me gustaría ver esto mismo pero de un cilindro para timón de botes, gracias

[@paulidulusi5249]

This is helpful. Thank you so much.

[@pedroalexanderhernandezriv2691]

muchas gracias

[@jorgemendoza532]

Nesecito con parar un cilindro telescópico de 5secsiones dle ansion

[@dlewis4647]

Hoping you can help me. I have a dump trailer with single acting telescoping cylinders. Today, they went up but on the way down they stop at transition to second stage, like a physical stop. I can continue to raise and lower through the first stage but can't get it to start lowering second. Thoughts?

[@erickhernandez-xk8xm]

Have you figured out what was wrong

[@user-ro9tk5tc7w]

J'adore ça

[@robertdoucette6858]

Will this procedure be the same for most hoosts? I have a Custom Hoist I’d loke to try this on to save some $$

[@gulabkeerio1930]

good job

[@wailelemcmillan8187]

Aloha was wondering I have almost Same cylinder but the sleeve tool you have with the prongs on the end my cylinder don’t have holes to put any prongs inside to remove last part to pull the shaft out any expertise will be appreciated

[@user-lp9ye1po3w]

Did you ever figure this out

[@JonathanMikombe-ws3wo]

😮😮😮

[@MaheshbhaiBhai-x9i]

Ok

[@robinelizalde195]

K pasa si keda al revés el empake por equivocación

[@anupgorai5576]

Oil leak takes place...

[@tommysmith4663]

Maybe this hydraulic cylinder is produced by our factory

[@juannunezgenao6763]

76 te

[@maxstewart4126]

how much ?

[@estherpaucararostegui136]

Bb