Husqvarna 390xp Rebuild
HTML-код
- Опубликовано: 29 сен 2024
- I bought a used 90cc chainsaw with the hopes of getting it running and turning it into a milling chainsaw. It had low compression and was clearly run with straight gas. I bought and installed a piston and cylinder kit as well as some new plastics. Enjoy!
Superbe dépannage réparation bravo c'est un chef ça mérite bien 2 pouces
Why would you put it together dry
bucking spike is on upside down.
does the 390xp have crank seal on the PTO side?
Good to see ya again! Hope you’re doing well.
straight gas??? OMG poor chain saw !!
Ok when u put the new gasket on and put the new cylinder on u didn’t use any sealant ??
Never use those Oregon spark plugs there junk , ruend one of my saws with those plugs
If I'd a known it was ran with straight gas I would have put a new bottom end in it.
Thank you, this was easy to follow along with. Superb job on the cuts / edits puns intended lol.🤘🤠🤟
Ready for Freddy
Made in Brazil?
como estas hoy señor
Hola señor
Sounds like a beautiful machine now!
@@LukeMixter Friend, what is the best max speed for 372 xp oem?
@@LukeMixter Friend, if the saw 372 xp after replacing the OEM piston, the compression will increase? after a few tanks now it is only 140 psi after refurbishment
@@LukeMixter can i set 13200 rpm for 372xp oem after one blown tank? saw after replacing the piston ...
Lots of rookie mistakes but you'll figure it out
amateur