thanks for the help, worked flawlessly for me! I didn't even remove the jet, I just used a twist tie removing the plastic to expose the metal wire and that fit perfectly into the jet to remove the clog, then flushed the jet with some carburetor cleaner and wiped the junk from the bowl then it started right up like a champ!
Thank you, very much. This fixed mine as well, my side jet was so clogged welding tips would not work, I needed to use an extremely small drill bit to get through the gunk, runs great now!
Glad this helped, sometimes the debris blocking the jet is very hard/compacted in. Just be careful with a drill if the bit is too big you can mess up the jet. You can also use a bristle from a steel brush
I cannot find just the bowl gasket for this carburetor. Mine fell out and it has expanded and I cannot get it to seal properly. I have looked all over the internet. Please tell me where I can find one. Thank you.
I don’t know if they sell the bowl gasket separately….sometimes if you can find one a little bit smaller you can stretch it to work…you probably won’t be able to find only the bowl gasket…except for Honda and Subaru it seems most mfg’s only offer kits.
For sure...I didn't expect it to have .1 hours on it. I expected a bit of use but the wins are nice. As of now I'm keeping it as a backup/unit to lend out but if I get a good offer I'll sell it.
you can take the airfilter cover off the squit some in, however, prefer to take the breather tub off since it's rubber and take a second to pull off and put back on.
thanks for the help, worked flawlessly for me!
I didn't even remove the jet, I just used a twist tie removing the plastic to expose the metal wire and that fit perfectly into the jet to remove the clog, then flushed the jet with some carburetor cleaner and wiped the junk from the bowl then it started right up like a champ!
Thank you, very much. This fixed mine as well, my side jet was so clogged welding tips would not work, I needed to use an extremely small drill bit to get through the gunk, runs great now!
Glad this helped, sometimes the debris blocking the jet is very hard/compacted in. Just be careful with a drill if the bit is too big you can mess up the jet. You can also use a bristle from a steel brush
I cannot find just the bowl gasket for this carburetor. Mine fell out and it has expanded and I cannot get it to seal properly. I have looked all over the internet. Please tell me where I can find one. Thank you.
I don’t know if they sell the bowl gasket separately….sometimes if you can find one a little bit smaller you can stretch it to work…you probably won’t be able to find only the bowl gasket…except for Honda and Subaru it seems most mfg’s only offer kits.
Nice! Always a win to get a good deal, and it's a simple fix.
For sure...I didn't expect it to have .1 hours on it. I expected a bit of use but the wins are nice. As of now I'm keeping it as a backup/unit to lend out but if I get a good offer I'll sell it.
Mine is not starting. Will try this this week. Thank you.
Appreciated your vid. Question.. where do I shoot the starter fluid. (Newby here)
you can take the airfilter cover off the squit some in, however, prefer to take the breather tub off since it's rubber and take a second to pull off and put back on.
It's not worth