IHI/ABB Turbo Charger Overhaul Model TPS 52

[@ShInYaKu88]

Nice, im producing the bearing housing for this turbo charger :)

[@MrCerobong]

​ @kurisensyotv7086 . please share the manual where it is mentioned tightening torque for the compressor wheel. I couldn't find it.

[@anthonyagustin8580]

Ganda ng Vlogs nyo Sir

[@florianbaumberger8090]

What about balancing of the rotor? A rotor with 800rps in operation should be balanced after cleaning! I would recommend to contact one of more than 100 Accelleron (former ABB turbocharging) service station to perform a professional overhaul!

[@bicolcebu7890]

Ano position Ng piston ring Doon s turbine side yong gap nya nagdikit ba

[@soehtikeminn531]

Good

[@allanfacto7635]

Sir baka pwidi pasilip tightening table para sa comptessor wheel tps48D01

[@joeldicksiaton7061]

Sir ilan yung tightening torque ng T/C foundation bolt?

[@rolandantonio2029]

What was the specific torque applied during re tightening of the compressor wheel sir🙂

[@kurisensyotv7086]

Our torque was 260nm but it depends on the manual that you have.. please see your instruction manual to be sure.

[@famebox8425]

​@@kurisensyotv7086 .. please share the manual where it is mentioned tightening torque for the compressor wheel .. I couldn't find it