A lot of people will see this that just want amber turn signals instead of red. It is a safer option. You can wire this module up so you can put a switchback bulb in your reverse light section of your tail light. VLEDS did this with the Tacoma, and it’s called VTails. I did this in my Dodge sedan that had a stop and turn setup. Very easy and recommended mod.
The hazards end up being converted to a brake signal. I have a led strip and it just flashes the entire strip instead of just the turn signals. When pressing the brake pedal and one turn signal at the same time it causes to hyper flash the turn signal. Without the brake pedal being applied it functions normally sequentially. For the life of me I can’t figure out how to get everything to work 😢
I tried this method but when i press the break it sends a .5s flash to the turn signal wire then turns it off and powers the break light. Might try your module mine was different
A lot of people will see this that just want amber turn signals instead of red. It is a safer option. You can wire this module up so you can put a switchback bulb in your reverse light section of your tail light. VLEDS did this with the Tacoma, and it’s called VTails. I did this in my Dodge sedan that had a stop and turn setup. Very easy and recommended mod.
Thats smart! a little safer and it helps you stand out
And what happens on hazard lights
The hazards end up being converted to a brake signal. I have a led strip and it just flashes the entire strip instead of just the turn signals. When pressing the brake pedal and one turn signal at the same time it causes to hyper flash the turn signal. Without the brake pedal being applied it functions normally sequentially. For the life of me I can’t figure out how to get everything to work 😢
Definitely wanna try this on my Escape. From the factory there's a small provision for signals, but it's blanked off 🤔
What year escape?
@@nascardrawings7700 2012. 1st Gens have amber signals, but they use a relay system while the 2nd Gen uses BCMs
hmmmm maybe you drill it out and put in a bulb haha
@@RazoE depending on what your reverse bulb is you can put a switchback bulb in your reverse light
@@zaccook that's the plan!
I tried this method but when i press the break it sends a .5s flash to the turn signal wire then turns it off and powers the break light. Might try your module mine was different
oh that sucks! To be honest im not 100 percent sure if this one had a delay or not as I couldn't see it when setting the brake lol
Grab a new relay I did that stopped the hyper flash
🎉🎉