thank you tech acad!!!! i have a question... whats the difference between configuring a Port Channel group and choosing those interfaces? Example: conf t interface range fa 0/5-6 OR interface port-channel 3 whats the difference? thank you!!
Once you create the port channel, it will create the Port-Channel Interface. So if needed to make any changes on those bundled interfaces, configure the interface Port-Channel! Thanks for your great support and sharing my dear friend!
Man you saved me, I was just looking for a tutorial to explain to me these configurations and a friend recommended me this video. Thanks a lot!
Glad it helped!
The video is great man. You explain it clearly and I like the point "Now we verify the configuration..." :)
Thank you so much my dear Friend for your great support...
i was just reading about the subject in a Cisco press book, thanks for being so clear, its very helpful.
Thank you
Yeah thats true
Impressive video tutorial. Thank you for sharing. God bless you.
So nice of you
Excellent ... well done ... with Scripts ...
Glad you liked it!
thanks a lot for the brief discussion
thank you tech acad!!!! i have a question... whats the difference between configuring a Port Channel group and choosing those interfaces? Example:
conf t
interface range fa 0/5-6
OR
interface port-channel 3
whats the difference? thank you!!
Once you create the port channel, it will create the Port-Channel Interface. So if needed to make any changes on those bundled interfaces, configure the interface Port-Channel!
Thanks for your great support and sharing my dear friend!
Thank you this really helped me again
Glad it helped!
thank you alot of --
how to check the result? the throughput and bandwidth?
It's very useful,could upload more videos.. thanks
Thank you And I will upload more videos in forth coming days.
hi, So you go to port channel and make it mode trunk. that is ok. so does it need to go in to physical interface and make it trunk too ? thanks
It will work both ways!
Thank you so much for your great support and sharing my dear friend!
outstanding!
Glad you like it!
how to check the result? the throughput and bandwidth?
When you run show spanning - tree command one of the link show block
god bless u!!!!!!!!
Why S1 to S3 not green?
You may seen the Amber or Orange color, because here STP blocks the redundant path to avoid loop!
simulation could ve helped u explain in a better way about load balancing
Thank you so much my dear Friend for your great support...
@@TechAcad anyways its still the best tut i ever had so far in etherchannel...Thumbs Up!!!
you have thought pin to pin the video great and very informate can you please send the note of that common which you have write in the side
Glad you like it!
@@TechAcad can you send me the note
@@TechAcad can you send me note which you are used in the vedio
In onw word,
print(" thank you "*100000).
Welcome 😊
8:40