1:58 good comment about rotating the vent to face the house. Have heard that these rust pretty quick, so would be keen on your views as to how they're stacking up a year on (both as a the rust-proof finish and if it's made a difference in heating/cooling).
Good video, I believe the Aluminium type that you install doesn't rust compare to the metal ones, it's been a year since your post please confirm if any sign of rust.
@gurusevuppal758 sorry can’t recall, I have a ridiculous amount of screws & just used some of what I had. Recommend using a stud finder if worried about stud locations or old school knock method. Location wise I just roughly spaced them out evenly
1:58 good comment about rotating the vent to face the house.
Have heard that these rust pretty quick, so would be keen on your views as to how they're stacking up a year on (both as a the rust-proof finish and if it's made a difference in heating/cooling).
Hi, sorry for delay. They have not rusted at all which is great. I believe they have made a difference, if only slightly
Dude, its aluminium. Physically impossible to rust.
Correct, it can corrode though
Good video, I believe the Aluminium type that you install doesn't rust compare to the metal ones, it's been a year since your post please confirm if any sign of rust.
Hi, there’s been no rusting at all
Hi mate, wondering what screws did you use and how did you go about selecting a location and detecting studs?
@gurusevuppal758 sorry can’t recall, I have a ridiculous amount of screws & just used some of what I had. Recommend using a stud finder if worried about stud locations or old school knock method. Location wise I just roughly spaced them out evenly
Good Job. How much were those vents mate?
Around $23 for a 2 pack
@@projectlex Damn. Aussies getting ripped off. $3 each in US.
That was 2 years ago, they have probably gone up since then. Yeah we get ripped hard with everything
@@projectlex Think Ill bring a few to Aus when I'm back down there. Have a good one.
Fill the suitcase up haha.
What did you use to cut the holes?
Used a circular saw