JP I believe my cousin called you guys yesterday in regards to his order a 10” apocalypse he called me right after he got of the phone he was excited I was the one that told him to get that sub
Can we get real clamp numbers at 14.8v I don't know anyone who is running 18v that's crazy high voltage and not used on the average it's mainly in 12 volt world in car audio thanks for the video
@@chuckholmes2075 They measured the amps and volts @ the amplifiers subwoofer outputs = the actual power output! If they had clamped the amperage pulled through the amplifiers power inputs, then multiplyed by the voltage, you would take eff. Into the equation.
@@evilinside5984 clamping is not accurate. That’s if the power factor was 1.0 which it never is. It’s typically only 80% of what’s measured. A lot of the power in is wasted on heat.
@@ReLLaXX48 are they way better than tweeters, are they loud AND clear, can they really play 500 Hertz or should you play them only at 1k+, do they come in pairs or is it $300 for a single horn. Do you have experience with these horns? If so would you recommend them?
That clipped signal will blow that amp especially if wired low like most SPL ppl who would buy this ... not smart to advertise clipping to achieve a wattage number ..
Yeah, better at al least 14v, not 18v its loot of investemnt in batteries and alternators, and yeah for another dude, there is amp than can run over 10kw at 12 and some vollts, for exanple cressendos can do at 13 and some, at their ratted power dc audio allso can ^_^
What a beast!
Are the avatar amps Korean or Chinese?
Lol beast is an understatement lol
JP I believe my cousin called you guys yesterday in regards to his order a 10” apocalypse he called me right after he got of the phone he was excited I was the one that told him to get that sub
@@agonydaddy Korea if I'm not mistaken
@@bellaphone5719 THANKS
So it's just a 12k capable of 18v
My friend has a 12AAK it’s a surfboard 🔊🏄🏼♂️🔊
Nice amp 😃👍
Amazing!!!! You guys are crazy in a good way lol :-)
When your nuclear aircraft carrier needs a Tweeter amp
Is this a half or full bridge amp
What will it do at 14 volts?
AWESOME BROTHERS!!!
no they're dumb as fuck
That is badass!!
Are the avatar amps Korean
Can we get real clamp numbers at 14.8v I don't know anyone who is running 18v that's crazy high voltage and not used on the average it's mainly in 12 volt world in car audio thanks for the video
Duh phuck is a cubit?
So it didn't play 20k watts @ 16v?
@Peyton Cole NO IT DID NOT... that's the power is took in BUT NOT WHAT IT PUT OUT. typical class D amps are only 70% efficient..
@@chuckholmes2075 They measured the amps and volts @ the amplifiers subwoofer outputs = the actual power output! If they had clamped the amperage pulled through the amplifiers power inputs, then multiplyed by the voltage, you would take eff. Into the equation.
@@evilinside5984 clamping is not accurate. That’s if the power factor was 1.0 which it never is. It’s typically only 80% of what’s measured. A lot of the power in is wasted on heat.
@@chuckholmes2075 Also the phase angle is prob. not figured in, which shows a higher wattage, just based off of max/peak amperage, and voltages.
@@chuckholmes2075they are using a resistive load so power factor with be very close to 1.0 and no phase issue to adjust
The translator sound familiar sounds garage 54 channel 😃
What was the ohm load ?
Mike 808 1 ohm
Review the Db d75neo horn
What do you want to know about them?
@@ReLLaXX48 are they way better than tweeters, are they loud AND clear, can they really play 500 Hertz or should you play them only at 1k+, do they come in pairs or is it $300 for a single horn.
Do you have experience with these horns? If so would you recommend them?
Chavy Cash it’s not better or worst than tweeters, different thing. Better to use tweets and horns. Comes as a single piece not in pairs.
That translation remind of old Chinese movie lol 🤣
MN91/30 20K
That clipped signal will blow that amp especially if wired low like most SPL ppl who would buy this ... not smart to advertise clipping to achieve a wattage number ..
They got 19,000 watts at 15.9 volts. WTF are you talking about?
19k is a hardcore amp .....
@@nicholasthompson3835 WROONNGGGG... after efficiency it was about 15k
Try it at 12v n c 18 wtf
10k Rms why would you even think something like that would even run on 12 v Do you know anything of car audio ?
Yeah, better at al least 14v, not 18v its loot of investemnt in batteries and alternators, and yeah for another dude, there is amp than can run over 10kw at 12 and some vollts, for exanple cressendos can do at 13 and some, at their ratted power dc audio allso can ^_^