do you have to go back and bed your top and bottom of tape with knife?? or does you applicator and flusher get it down tight?? iv been rolling but the roller tends to pull out the tape at tops and bottoms of the angles and i always have to run back and set them with a knife and i usually end up pulling to much mud off...
I bed the top with a long handled knife from the floor. I flush up from the bottom so no need to bed it. Sometimes the flusher does the 3 way just fine. Don’t press too hard on the roller and keep your roller wet by dipping it in water every 2 or 3 angles. The roller gets a little too sticky if it's not wet.
Thanks ! No I did not Gordie. Pulling mesh out of the corners did not turn out to be as easy as I thought it would be. I just taped over top with paper after I sanded out the corners.
nice to see you again, nice video as we would like to see more often!
I appreciate your kind words. Thank you !
Love the tube work, the new head looks interesting and look forward to seeing more
Thanks. It is pretty fancy. Slight learning curve.
nice vid 👍.. just one quest, doesnt ur mud pour out of the tube when u keep it downwards in a bucket?
Not at all. When we say soupy we mean it's very "loose". Best way to describe it is pancake batter mix.
do you have to go back and bed your top and bottom of tape with knife?? or does you applicator and flusher get it down tight?? iv been rolling but the roller tends to pull out the tape at tops and bottoms of the angles and i always have to run back and set them with a knife and i usually end up pulling to much mud off...
I bed the top with a long handled knife from the floor. I flush up from the bottom so no need to bed it. Sometimes the flusher does the 3 way just fine. Don’t press too hard on the roller and keep your roller wet by dipping it in water every 2 or 3 angles. The roller gets a little too sticky if it's not wet.
So nice to hear you yack at 2 times the speed🤣😂
Great work again . Did you prefill you inside angles?
Thanks ! No I did not Gordie. Pulling mesh out of the corners did not turn out to be as easy as I thought it would be. I just taped over top with paper after I sanded out the corners.
Give it a little shake 🤣😂