Thanks for the free education .. ive ben akeptical about the cheap chineese waste gates and blow off valves .. your video show me theres nothing much that can go wrong and if i take it apart and finesse /massage the inside it will make it even better .. kinda like my ole deer riffle just before deer season !!!
I use 2x 50mm Pulsar wastegates, I got my 50mm blow off valve from Pulsar, and my Turbo a s498 ball bearing Turbo from them and my heat shield nappy from them as well all work exactly as they should no issues at all only part I use turbosmart eboost 2 boost controller, my 427 LS makes 1600hp
Great video man 💪🏼 I was a little nervous about using a cheap wastegate but this definitely made me feel better what set up did you use it on how is holding up ?
Or how much boost/pressure you put against it. You could run well over 50/100 psi boost jus depends what boost controller you have or boost control set up, Or yes what spring you have if boost control isn’t a factor
![How To PROPERLY Clock a Turbocharger [Do It Right To Avoid Damage]](http://i.ytimg.com/vi/384ByQe7gMg/mqdefault.jpg)
Do this and then lap the valve to the fire ring and never have a problem with sealing either. Good vid.
Thanks for the free education .. ive ben akeptical about the cheap chineese waste gates and blow off valves .. your video show me theres nothing much that can go wrong and if i take it apart and finesse /massage the inside it will make it even better .. kinda like my ole deer riffle just before deer season !!!
Yup! Nothing to it 👍 thanks for stopping by 🙏
I use 2x 50mm Pulsar wastegates, I got my 50mm blow off valve from Pulsar, and my Turbo a s498 ball bearing Turbo from them and my heat shield nappy from them as well all work exactly as they should no issues at all only part I use turbosmart eboost 2 boost controller, my 427 LS makes 1600hp
Great video man 💪🏼 I was a little nervous about using a cheap wastegate but this definitely made me feel better what set up did you use it on how is holding up ?
I used it on the Honda del sol turbo build. Thank you 🙏
What about the rubber prong under the nut?
You don’t upgrade it??
Put a copper washer ??
Nothing??
No need to.
Hi, I know it's been a long time but did you have any problems after this upgrades on wastegate? Or does it hold strong?
Holding up just fine! Still running strong like Usain Bolt 👍
What psi does it open up at with just running that short spring?
about 4 with that spring. the sturdier spring about 10 psi
If underboost this methood can solve
How much psi this wastegate can hold?
depends on what spring you put in
Or how much boost/pressure you put against it.
You could run well over 50/100 psi boost jus depends what boost controller you have or boost control set up,
Or yes what spring you have if boost control isn’t a factor
so didn't you just rub off the coating and it'll rust down the road?
why would it rust?! water doesn't go through your wastegate bud!
@@FullThrottleGarage69 Heat creates corrosion, it means by taking the coating off, you can rust the valve because of the heat..
you literally just told people to destroy the seat contact area
Lol ok bud
@@FullThrottleGarage69I’m not wrong, you lap valves against the seat for a reason bud. The fact you don’t know this is hilarious.
dRY
This video should have been 2 minutes long
Your mom was 2 minutes long 😃