Awesome Homemade Cross Slider And Screw Nut Threading Going to Work
HTML-код
- Опубликовано: 8 апр 2023
- #homemadelathe #mrranyhomemade #crosssliderlathe
Awesome Homemade Cross Slider And Screw Nut Threading Going to Work
New projects homemade lathes bed (second lathe)
Hello RUclipsr, today I’m glad to share my new second homemade lathes.
I do happy to make a bigger size because my first lathe the size is a bit small, when milling a big plate of thick metal is not easy because the length is not enough space to milling than the plate metal I used is thin most are 10 mm thick.
So I decided to make a new lathe bigger than the previous lathe. Now there is enough experience to make a new lathe also.
I hope you all enjoying my new lathe from part 1.
• #Diy #Craft #Tools Do ...
• Homemade Lathe Machine...
• Awesome Cutting slider...
• #homemadecuttingslider...
Dear all beloved fans and subscribers,
Welcome to my channel Mr. Rany Homehome.
Today, I have new video about:
I would like to show you how to make local furniture made of steal, iron, wooden products. Hope you enjoy watching my activity.
-Awesome ideas
-Tips
-Craft
-How to make
-Create Ideas
-DIY
-Life Hack
-Others
Please help me to like, comment, share and subscribe my channel to reach my goal 100,000 subscribers.
With regards
Mr. Rany Homemade 
Наука
Olá meu amigo trabalho perfeito, muito boa a ideia!!!Lhe desejo sempre muita saúde e cada vez mais sucesso!!!
Abraço
Olá meu querido amigo, como você está? como você tem estado? obrigado por assistir espero que tenha gostado qual é o seu projeto? eu espero tudo de bom
Vary good job thank you
Thank you for reaching I do hope you like it
Good job!
Thank you my friend
wonderful effort👍👍
Thank you, too for doing your best to watch
Nice job brother ❤❤❤
👍🙏
Thank you
Muito bom seu trabalho; gosto muito de ver seus videos. muito o brigado amigo.
Boa tarde amigo tá ficando tope que Deus abesoi
good job I think you are going to have to put an adjustable slider inside your cross slide to take up side-to-side movement in it as it wheres out.
Many thanks I appreciated your introduction because I had stuck ideas too sometimes.
Otherwise, I make it not in the role of a homemade lathe sometimes made this or a different way because behind the scene very hard to make these cause I don't have any tools and equipment enough. Right now I'm stuck gear rack for the tracking carriage where do I get it? I could find it online but I don't have an address because I'm living in the village. So my work is always slow.
Thank you for watchingng...
Respekt vor ihrer Arbeit! Ich sehe den Kanal gerne. Leider kann RUclips nicht übersetzen,
perhaps it is better not to go so deep with the milling cutter with your homemade drill.
Thanks