Replace Glow Plugs In Your Car | Test Diesel Glow Plugs | 1.3 D | Swift Ritz Ciaz | Fiat Punto Linea

Поделиться
HTML-код
  • Опубликовано: 1 ноя 2024

Комментарии • 89

  • @ericcartmansn4737
    @ericcartmansn4737 2 года назад +3

    Great. I renewed glow plugs of my corsa thanks to this guy. Thanks mate. I hope you teach us more thing.

    • @dailyhandsdiy
      @dailyhandsdiy  2 года назад

      Hi,Glad to hear from you mate n sure will be updating...

  • @arunkumar-xc3ms
    @arunkumar-xc3ms 2 года назад +2

    Great useful video .i found my one plug damage ❤️ if i not aware showroom willl charge for 4 plugs.

  • @vijayam1
    @vijayam1 3 года назад +3

    Long time mate, great to see you wrenching again. If only the Ford's 1.5 was reachable as this Fiat. Do make a video for the Ford 1.5 TDCi glow plug if time permits. :D

    • @dailyhandsdiy
      @dailyhandsdiy  3 года назад

      Absolutely will do when i get a chance mate. And you r ryt, ford has these plugs sits on the other side which is a bit hard to reach.

    • @mandarshrotri5679
      @mandarshrotri5679 2 года назад +1

      Was going to ask the same question about Ford 1.5 tdci. But read the post.
      Also I want to ask if there is a glow plug light in the Ford's meter. If yes my light does not glow. Also how many seconds does the glow plug on Ford aspire glow at cold start.
      Regards

    • @dailyhandsdiy
      @dailyhandsdiy  2 года назад

      @@mandarshrotri5679 Yes there's a symbol on dash board but it does nothing. when ever there is a fault in plugs, engine malfunction light flashes.(A gear shaped symbol).
      Usually at cold starts, an initial 3 seconds warm up time is provided when we turn the ignition on. Then it glows completely while cranking.

    • @mandarshrotri5679
      @mandarshrotri5679 2 года назад +1

      @@dailyhandsdiy thanks for your instant reply 👍

    • @dailyhandsdiy
      @dailyhandsdiy  2 года назад

      Any time brother

  • @SSPCars
    @SSPCars 2 месяца назад +1

    I'm thinking to replace the glow plugs of my harrier by myself. Do you recommend?

    • @dailyhandsdiy
      @dailyhandsdiy  2 месяца назад +1

      Yes you can DIY. use wd40 before removing.

    • @SSPCars
      @SSPCars Месяц назад

      ​@@dailyhandsdiy👍

  • @SSPCars
    @SSPCars 2 месяца назад +1

    Can i hand tighten the glow plugs while installing back coz I dont't have the torque wrench?

    • @dailyhandsdiy
      @dailyhandsdiy  2 месяца назад +1

      Yes ofcourse. just dont give too much pressure...simple hand tight will do the job.

    • @SSPCars
      @SSPCars Месяц назад +1

      ​@@dailyhandsdiyThanks!

    • @dailyhandsdiy
      @dailyhandsdiy  Месяц назад +1

      @SSPCars Anytime bro

    • @SSPCars
      @SSPCars Месяц назад +1

      @@dailyhandsdiy I am getting P0673 & P0674 dtc code currently, is it ok to repace only defective plugs or should i change the entire set? My car is just 3 years old, how did it fail?

    • @dailyhandsdiy
      @dailyhandsdiy  Месяц назад +1

      This could happen to any new cars as well. There might be an issue in manufacturing lot. Could just replace the 2 of em. and wait for others to go out before swapping.

  • @xbrutal3953
    @xbrutal3953 2 года назад +1

    Hello i have one question...
    Before you have replaced glow plugs...
    Engine[motor] was shaking?
    Motor vibration?

    • @dailyhandsdiy
      @dailyhandsdiy  2 года назад +1

      Nop it was smooth..just the light flashing, delayed start and a bit of white smoke for sometime.

    • @xbrutal3953
      @xbrutal3953 2 года назад

      @@dailyhandsdiy i have problem with 4th plug. ..i have to replace it but motor engine is shaking more than normal so someone told me that plug cuold cause shaking

  • @saitech5668
    @saitech5668 Год назад +1

    I have a fiat linea 1.3MJD I was trying to remove a glow plug from car this time the glow plug is broken 3 glow plugs are working 1 plug is broken so will there be any problem in future

    • @dailyhandsdiy
      @dailyhandsdiy  Год назад

      If it's broken at the tip, it can slip into the cylinder and cause some serious trouble. or if it's broken in middle or from top leave as it's is...need some special tools to remove.

    • @strrudtc
      @strrudtc 7 месяцев назад

      have you removed the broken part?

  • @intyjosephrajkumar6239
    @intyjosephrajkumar6239 2 года назад +1

    Hi bro. Hope you were doing good. I'm seeing the gear ⚙️ symbol on my ford fiesta dashboard. It is blinking for sometime and when I stop the car and start it vanishes. What will be the reason? Thanks in advance.

    • @dailyhandsdiy
      @dailyhandsdiy  2 года назад

      Hi there, do check if the car revs till 2.5 or 2k rpm when the symbol flashes. If the car runs goods with no vibration then mostly its a glow plug issue. If the car does not go beyond 2k rpm and vibrates then its a fuel related issue like injector pump regulator etc..

    • @intyjosephrajkumar6239
      @intyjosephrajkumar6239 2 года назад +1

      @@dailyhandsdiy Got it. Thanks bro. 🤘

  • @nikolapetreski2135
    @nikolapetreski2135 2 года назад +1

    DIY tutorial was very useful 👍🏻thank u

  • @akashaaga6111
    @akashaaga6111 4 месяца назад +1

    Bro my Fiat Punto diesel showing check glow plug symbol for 30s after few sec its gone may I know exact problem weather I want to replace glow plug are not

    • @dailyhandsdiy
      @dailyhandsdiy  4 месяца назад

      Yes you need to replace the glow plugs.

  • @RR310_RIDER_
    @RR310_RIDER_ 11 месяцев назад +1

    whats the price. in my vista that indicator blinks and stop blinking after starting the engine.so whats the problem???

    • @dailyhandsdiy
      @dailyhandsdiy  11 месяцев назад

      it's the glow plugs, one cost around 800 plus or minus Bosch brand...

  • @wezopechirhah7996
    @wezopechirhah7996 3 года назад +1

    Hi bro, here I have a question, my ecosport slow fan is not working even when AC is on, where do I have to start to check the fault. The high speed is working.

    • @dailyhandsdiy
      @dailyhandsdiy  3 года назад +1

      There's is a small thing on right bottom of fan shroud, 2 wired. Its called low speed resister. jst replace that n you are ready.

    • @dailyhandsdiy
      @dailyhandsdiy  3 года назад +1

      oh also check the fan relays too, mostly the resister goes bad.

    • @wezopechirhah7996
      @wezopechirhah7996 3 года назад +1

      Thanks buddy for quick reply.

    • @dailyhandsdiy
      @dailyhandsdiy  3 года назад

      Any time bro.

  • @sbala2719
    @sbala2719 Год назад +1

    On what Torque value the Glow plug have to be remove and install please?

    • @dailyhandsdiy
      @dailyhandsdiy  Год назад

      It depends on the car.... normaly 15nm to 23 nm is safe.

    • @sbala2719
      @sbala2719 Год назад +1

      @@dailyhandsdiy thanks brother

  • @LetsFactoryReset
    @LetsFactoryReset 3 года назад +1

    DIY tutorial was very useful 👍🏻thank u😍

  • @somumallikarjunareddy1284
    @somumallikarjunareddy1284 3 года назад +1

    What the tools you are used to remove glow plug.can you tell me that .which number

    • @dailyhandsdiy
      @dailyhandsdiy  3 года назад

      Its 8mm deep socket 1/4th inch drive, a ratchet and extension.

  • @Rolandspdsx
    @Rolandspdsx 10 месяцев назад +1

    Meri TATA ZEST ka ek glow plug andar hi tut gaya hai yeh kaise niklega,,,,agar na nikla to andar koi problum to nahi karega,,,,,,plz reply

    • @dailyhandsdiy
      @dailyhandsdiy  10 месяцев назад

      it's a bit dangerous to the engine. that small bit can get trapped in valve seats or can hit continuously on the cylinder or head or piston walls making wear n tear...best is to dismantle the head to remove the piece.

    • @strrudtc
      @strrudtc 7 месяцев назад

      @shimu - have you removed the broken part?

    • @Rolandspdsx
      @Rolandspdsx 7 месяцев назад

      @@strrudtc yes

    • @strrudtc
      @strrudtc 7 месяцев назад

      @@Rolandspdsx pls explain the process and cost involved?

    • @Rolandspdsx
      @Rolandspdsx 7 месяцев назад

      @@strrudtc aap kaha se ho,,???
      Aur aap ki kon si gaddi hai

  • @vigneshr2502
    @vigneshr2502 2 года назад +1

    How much it cost for replacement for one piece. I am using bento VW ?

    • @dailyhandsdiy
      @dailyhandsdiy  2 года назад +1

      Oem part can cost anywhere btwn 2.5 to 3k for a piece or could use aftermarket like Bosch for less than 1k.

    • @vigneshr2502
      @vigneshr2502 2 года назад +1

      @@dailyhandsdiy thanks brother for your reply

    • @dailyhandsdiy
      @dailyhandsdiy  2 года назад

      Any time brother

  • @abcxyz5818
    @abcxyz5818 2 года назад +1

    I had same problem with my Fiat Punto, the KHT service supervisor said that there won't be any issue as there are 4 plug and 1 is having problem still I can drive the car.

    • @dailyhandsdiy
      @dailyhandsdiy  2 года назад

      Sure you can drive the car...no worry. They come in handy where temp is extremely low.

    • @xbrutal3953
      @xbrutal3953 2 года назад +1

      When you have that problem your motor engine was shaking? Have vibration?

    • @abcxyz5818
      @abcxyz5818 2 года назад +1

      @@xbrutal3953 no shaking nor vibration.

  • @Saravs0707
    @Saravs0707 10 месяцев назад +1

    Why glow plug warning comes again after 1 month of replacement. Replaced all 4 before 1 month only.

    • @dailyhandsdiy
      @dailyhandsdiy  5 месяцев назад

      it means the new one has got a problem

    • @Saravs0707
      @Saravs0707 5 месяцев назад +2

      @@dailyhandsdiy yes you are right, the problem was with the new one and replaced. Now the problem gone.

  • @SuperGavardo
    @SuperGavardo 3 года назад +1

    Plz male video for Ford Fiesta 1.5 TDCi flow plug

  • @purushbainsla3379
    @purushbainsla3379 2 года назад +1

    How to remove broken glow plug?
    Plz answer?

    • @dailyhandsdiy
      @dailyhandsdiy  2 года назад

      hi there, is that the tip which is broken?

  • @mrigankabanikchoudhury5192
    @mrigankabanikchoudhury5192 3 года назад +2

    Very good video

  • @Rockyboy-ld8hv
    @Rockyboy-ld8hv 3 года назад +1

    great work... keep it up

  • @arunkumar-xc3ms
    @arunkumar-xc3ms 2 года назад +1

    Whats the minimum life of plug

    • @dailyhandsdiy
      @dailyhandsdiy  2 года назад

      There's no particular life for these plugs, could go anywhere btween 40k to 1 lk kms. if you drive mostly in citys n idles more often could fail much earlier.

    • @arunkumar-xc3ms
      @arunkumar-xc3ms 2 года назад +1

      @@dailyhandsdiy ❤️

  • @akheelpathan9648
    @akheelpathan9648 Год назад +1

    Sor ford figo howe to head remove vidios full aplod sar

  • @lininraj3951
    @lininraj3951 3 года назад +1

    👍.. Nice video

  • @taylordurdon4873
    @taylordurdon4873 3 месяца назад

    Glow plug
    Part number please