2011 2012 2013 2014 Hyundai Sonata Spark Plug Replacement

Поделиться
HTML-код
  • Опубликовано: 23 янв 2025

Комментарии • 31

  • @randonmangtamag9864
    @randonmangtamag9864 Год назад

    Thanks man such a great help

  • @bishop7534
    @bishop7534 4 года назад +18

    It's easier to take all the coils off together and place them on the side, no need in disconnect if not changing them out.

  • @6atlantis
    @6atlantis 4 года назад +3

    What do I set the torque wrench at for 2012 sonata plugs?

    • @unovere
      @unovere 3 года назад +1

      If you read the repair manual it should tell you. But normally between 15-20 ft/lb.

    • @6atlantis
      @6atlantis 3 года назад +5

      @@unovere actually it doesn’t and the instructions for new plugs say no anti seize which is odd, and they have a crush washer so just tighten firm then less than another quarter turn with ratchet. Idk.....

  • @AYVYN
    @AYVYN 2 года назад +7

    Pull out wire, remove ignition coil, remove spark plug. Repeat in reverse.

    • @madb9422
      @madb9422 Год назад +1

      Don't need to do that. You can keep each attached.

  • @erinanthony7443
    @erinanthony7443 3 года назад +2

    This was so awesome

  • @kham078
    @kham078 2 года назад +1

    Thank you so much so helpful!!!

  • @6atlantis
    @6atlantis 3 года назад +6

    How come they say not to use anti-seize and there are no torque specs because there’s a crush washer?

  • @stevensanchez8230
    @stevensanchez8230 4 года назад +1

    What if someone mixed up the correct order of the coil packs how do I figure out the rite way they go again???

    • @bishop7534
      @bishop7534 3 года назад +4

      Shouldn't be possible being the wires are lengthen to fit specific plugs..

    • @asdquet
      @asdquet 3 месяца назад

      It doesn't matter. They're all the same.

  • @scottyofeden
    @scottyofeden Год назад +1

    Does anyone know if the "turbo" version (Sonata 2011) has wires that need to be replaced as well? I've seen multiple videos that go over spark plug replacement... and none of them mention the wires. Thanks!

    • @madb9422
      @madb9422 Год назад +2

      No. It has coil packs & they don't need to be replaced unless you have an issue.

    • @scottyofeden
      @scottyofeden Год назад

      Thank you!@@madb9422

  • @newphone3594
    @newphone3594 3 года назад +3

    does the engine have to be cold or hot when you open spark plugs?

    • @drgfataldeath
      @drgfataldeath 3 года назад +5

      Better to do this when the engine is cold. So you do not burn your hands or arms

  • @meka2811
    @meka2811 5 месяцев назад

    Thank you!

  • @macduff1956
    @macduff1956 5 лет назад +12

    You don't need to unplug the coils.....

    • @kevinriles8093
      @kevinriles8093 5 лет назад +1

      You sure?

    • @macduff1956
      @macduff1956 5 лет назад +6

      @@kevinriles8093 I just did the job this week without removing the coils plugs
      ruclips.net/video/bIT6DfgYvd0/видео.html

    • @kevinriles8093
      @kevinriles8093 5 лет назад +3

      @@macduff1956 ok thanks man,

  • @odavid2580
    @odavid2580 5 лет назад +3

    Is this the same for Sonata 2010 v4? and how long did it take to complete?

    • @SuperScarface109
      @SuperScarface109 5 лет назад +1

      Probably it's the same taking into consideration that Hyundai uses the same design for their engines

    • @rahshonhicks3495
      @rahshonhicks3495 2 года назад

      Less than 45 mins

  • @harith7260
    @harith7260 2 года назад

    هاي شلون گدرت تفتح البلك بايد وحدة؟ 🤔

  • @nonagrams4656
    @nonagrams4656 3 года назад

    Do you know the firing order?

  • @LifewithNicoll
    @LifewithNicoll 5 лет назад

    What’s the spark plug gap ??

    • @DoritosRus
      @DoritosRus 5 лет назад +6

      Adrialey Ramos iridium plugs come pre gapped from manufacturer