Check DPF System Warning & Stuck In Limp Mode - Mitsubishi Triton - P1498 Fault - Found & Fixed

In this video I show a Mitsubishi Triton that is lacking power and stuck in limp home mode - It had a fault code stored of P1498 DPF overloading with the check DPF system and engine management light warnings on dash.
Thanks to everyone who watches my videos, Likes, Shares and or leaves a comment. I appreciate everyone of you.
Tool options that I recommend and use. www.amazon.co.uk/shop/gerardb...
➢ For business inquiries Email : [e-mail]
Disclaimer:
GerardBurke is a qualified motor technician who has completed modules & courses in manual handling and all aspects of workshop safety. These videos are not intended to be used by anyone who is not trained and or qualified to carry them out.
Due to factors beyond the control of GerardBurke, I cannot guarantee against improper use or unauthorized modifications of this information. GerardBurke assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. GerardBurke recommends safe practices when working on vehicles and or with tools seen or implied in this video. Due to factors beyond the control of GerardBurke, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not GerardBurke.
2013 2014 2015 2016 2017 2018 2019 2020 2021 2022
Outlander
#P1498 #DPF #Mitsubishi

[@MiracleMAX]

One of the most common faults on the turbo CRDs. They also push the hose off when they get old. Good explanation & thorough repair done 👍😉

[@GerardBurkeBurkesGarage]

Thanks mate, much appreciated 🙏🙏

[@Mr-Keating]

Great vid mate. Is definately a common problem and not just limited to mitsubishi.

[@patkelly7999]

Great work, as always Gerard💯👌👍🙏🙂

[@GerardBurkeBurkesGarage]

Thanks Pat, always appreciated 🙏🙏🇮🇪🇮🇪
Another one fixed 😉

[@gemmanaughton3693]

Great video❤

[@GerardBurkeBurkesGarage]

🙏🙏❤️❤️🙏🙏

[@bryden2008]

Was the pipe change enough to get it out of limp mode?

[@pololasss]

Hi, thanks for a video. What scan tool are u using?

[@GerardBurkeBurkesGarage]

Autel Ultra

[@armhags1643]

hi mate, i have 2016 triton mitsubishi the problem is dpf ligth on and limp mode, same dtc. if im trying to dpf regen its only affair on the scanner executing but the problem is the rpm not up to 2000. stay in idle. i used autel scanner. inlet hose ok.i cleaned dpf, there is any issues?