FIX P1696 Immobilizer Fault Code | Immobilizer Key Mismatched

In this video I show you how to test and fix the immobilizer system when there is P1696 Immobilizer Key Mismatched fault code.
#immobilizer
#p1696
#transponder
#key
#keyfob
Disclaimer:
Any information contained in this video is just the understanding of “KIA & Hyundai Diagnostics” and it is not an official guide or reference, so everything provided in this video is just a share of our experience and understanding and they are provided as a courtesy for your reference only. So, if you are using any part of this video, use the information at your own risk. We highly advise you to check the manufacturer owner’s manual before performing any act of removal, diagnosis, inspection, or repair on your car to know about what you are authorized to do on your car, what the correct and legal procedure is and what risks might be involved, also viewers are strongly advised to consult a licensed person before any sort of inspection or repair. Due to the factors beyond the control of “KIA & Hyundai Diagnostics”, we cannot guarantee against improper use of information or tools or systems, or the procedure provided. “KIA & Hyundai Diagnostics” disclaims any damage, injury or loss caused by your decision to follow the steps provided in this video.

[@sulemanhabib1743]

K h you are one of my favourite channels, thanks you

[@GoProAuto]

Thanks my friend. I’m glad you like the videos

[@PhongTran-jc7hw]

the video is very interesting. Thank you. I would like to ask if it is possible to use an oscilloscope to check the communication signal between the chip and detect the signal?

[@GoProAuto]

Hi my friend. Not between the chip and immobilizer, but you can check the signal between immobilizer unit and antenna coil

[@medch4193]

Good job my friend thank you

[@GoProAuto]

Thanks for watching

[@abedinramadani2963]

Hello, I have Kia Picanto 1.1 CRDi, the car wont start, when I put the key in the ignition and start, Nothing happends, the motorn dont even go around, its just a click sound, I get the immobilizer lamp on, but the car wont start anyway, I diagnosted the car with my computer ( Autocom) i got the faulty code immobilizer, I checked everything like you and everything looked good, when i put in the 1st gear and push the car, then it starts, my question to you, is it the immobilizer or the startmotor?

[@katlegokatlego8996]

Can you programme the transponder without a key blade?

[@GoProAuto]

Ignition switch must be on for programming

[@amarabdelli487]

Thanks friend

[@GoProAuto]

👍👍👍👍