@@Baron_Rutledge just take the last shot right back by the first one without crossing the line. It is not needed to have a perfect closed line to create the model. Including a stock pile outer boundary line. When you go to COGO to run the report, it will auto close it for you.
@@sitechintermountain I know about the stockpile outer boundary closing itself I was curious about the surface as design. Do you know which advanced measurement module you have? Thanks for the help.
@@Baron_Rutledge as far as I know there is only one advanced measurements module. You don’t have to have a closed boundary to finish out a surface as design option either if you don’t have it.
Thanks so much for the helpful instructions
Great video. Is there a way for Siteworks to display the elevations of your break line points?
hit the gear on the main screen under the measure tab have option for name,code,and elevation
Are the steps the same if you do this with a total station instead of a rover?
Yes, exactly the same for all the options on screen
What if I do not have the advanced measurements module for closing out the line?
@@Baron_Rutledge just take the last shot right back by the first one without crossing the line. It is not needed to have a perfect closed line to create the model. Including a stock pile outer boundary line. When you go to COGO to run the report, it will auto close it for you.
@@sitechintermountain I know about the stockpile outer boundary closing itself I was curious about the surface as design. Do you know which advanced measurement module you have? Thanks for the help.
@@Baron_Rutledge as far as I know there is only one advanced measurements module. You don’t have to have a closed boundary to finish out a surface as design option either if you don’t have it.