I applaud your efforts doing these type repairs. But you could have taken a piece of steel and flipped the case upside down and laid it on that piece of steel. Then cut a patch of aluminum to fit pretty close from the inside to fit the hole. Then merely aluminum weld around the edges and you would be finished, except to clean up and polish... Just an idea.
Great job, but I'm not sure that you revealed the secret. First time I tried to weld some cast aluminum, it quickly went bloop into a blob of useless aluminum. Next time I used a TIG welder, and it turned out much better. Amazing that you are able to do this with a flame torch.
What a shit, The amount of time and gas you wasted, instead of that, you should put it, on a flat surface in reverse and put melted aluminium on it, it would have given you, much more smooth and perfect joint
I applaud your efforts doing these type repairs. But you could have taken a piece of steel and flipped the case upside down and laid it on that piece of steel. Then cut a patch of aluminum to fit pretty close from the inside to fit the hole. Then merely aluminum weld around the edges and you would be finished, except to clean up and polish... Just an idea.
Saludos maestro de la soldadura que presión utilizas en los manómetros para soldar esos calibres? Por cierto magnífica reconstrucción 🎉
Your videos continue to amaze me. Truly an artist.
what are the sticks you're using for filling ?
MUY BUEN VIDEO!!!...SALUDOS DESDE MEXICO.
Great job, but I'm not sure that you revealed the secret.
First time I tried to weld some cast aluminum, it quickly went bloop into a blob of useless aluminum. Next time I used a TIG welder, and it turned out much better.
Amazing that you are able to do this with a flame torch.
What solder was used?
Que genio te felicito crak , una consulta que número de pico usas
Acetyline apakah bisa buat pengganti gas karbit bang..makasih
Это мастерство! Браво!
Bang kenapa sering tutup terus
Para sa akoah boss dugay man na imung gibohat
Nombre de la varilla?
el hace sus propias varillas usando pieza de aluminio descartadas.tiene un vid sobre eso.
Salam dari pemula kang support slalu 👍🙏
Lật ngược lại hàn còn nhanh hơn 😅
👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍👍
Bro u using flux or not bro,,,if use tell me the flux name
The flux name is electrodo 6011 es para mover la escoria y sobre eso soldas
日本では、燃料価格高騰の為にケースを買い替えた方が現実的である。
This is "secret?"
Mais que serviço porco😅
What a shit, The amount of time and gas you wasted, instead of that, you should put it, on a flat surface in reverse and put melted aluminium on it, it would have given you, much more smooth and perfect joint