DIY Sensors - Build your own Flex sensor, Pressure sensor and Vibration sensor
HTML-код
- Опубликовано: 31 май 2024
- Who would have guessed that building your own sensors could be so easy? And it is very cheap as well, as you might have everything that you need at home already.
We are building a Flex sensor, a Pressure sensor and a Vibration sensor.
Requirements
- Cardboard
- Paper
- Pencil
- Gluestick
- Tape
- Hot glue gun
- Aluminum foil
- Copper wire
- 10 kOhm resistor
Pick up all your electronic needs at our store
buyzero.de/en
Our PiCockpit webinterface allows you to control your Pi over the web
www.picockpit.com/
Need special hardware or software solutions? Contact us!
pi3g.com/de/
Check out our Blog to learn incredible things all around the Pi
picockpit.com/raspberry-pi/
buyzero.de/blogs/news
Music from Uppbeat (free for Creators!):
uppbeat.io/t/pryces/aspire
License code: KKAQM6BBTCJRBCAC 
Наука
Great video and good description of how to build these sensors. Maybe I missed it but it would have been nice to also see the flex sensor in action. Also I'd recommend to set the camera to a fixed exposure when recording the close-ups as your hands sometimes led to the frame being too dark.
Thanks :) Testing the flex sensor and pressure sensor works exactly like testing the vibration sensor.
holly cow - bless your soul for this information! thank you!
You are so welcome!
Thank you❤
remove and replace chime element with vibration element on motion detection receiving unit
Really nice video 😉 keep going !
Thank you! 😃
Absoluter Anfänger hier, hab jetzt mehrmals versucht, so einen Flex-Sensor zu bauen, aber wenn ich mein Multimeter anschließe, um den Widerstand zu messen, zeigt es mir nichts an. Jedoch wenn ich auf 200 mV stelle, sehe ich, dass sich was tut. Ich versteh nicht, was ich falsch mache.
would like to have seen the flex and pressure sensors in use. I need them to work really well for my project but really want to go this route because I need like 10 of them and it gets expensive when they are like $7+ each
Good luck with your project!
@@pi3g Thanks. Sadly it failed because the 3d printed parts were too bulky and 3d printed gears too noisy. Never even got around to doing the flex sensors lol.
Sir can you make a piezo sensor for violin bridge