Great review! In Russia, many of the same opinion about TK 7.0 It's just a show-off ... the 6.0S option was optimal. Everyone was happy with it, and this is a good budget option for infrared combat.
The lower hull also has the KV1 uparmour, that some KV1 had. I have never seen a KV2 with the additional armour plates. The swivel opening is a roof ventilator (to extract fumes from the fighting compartment) on the real tank.
I love your tanks. I am 49 and I just got the German Stut III. Really love the detail on the tanks and the ability to upgrade them. I think I may order this one today! Great stuff. Thanks a million for such cool tanks!!
Mine just arrived, it is the Tiger 1 v7.0 and there is an option that says something about double or normal current that when I try to drive the tank it makes it disconnect lol….
Would you recommend any specific Tamiya 1/16 RC kits for someone who hasn't ever built one before? I really want their Type 10, but I can't find any for sale anywhere (that doesn't look sketchy)
Can you recommend a good RTR Tank for a beginner that is good for IR Battles and under $250? Looking for possibly 1/16 scale maybe a little smaller. I saw some online that come in sets but looks very cheap in quality. I was hoping the IR device would be already installed since I am not very mechanically inclined. Thank you for any advice you have.
unfortunately, it's a mechanical thing. The BB motor is the recoil "motor" and the firing only works when the barrel/BB piston goes all the way back. Delaying anything will just delay the entire firing sequence
I just bought the Heng Long Sherman tank 7.0 ver. The only bad thing is that every time it starts up there is a loud beep (like a Toyota horn) than it starts up. Can that be disabled? I'm still learning all the functions.
Soo... What happened with the Sounds from the 6.0? Did Tamiya finally crack down on HL for ripping off their Sound Files and they now have to rely on the only two they recorded themselves or what?
Hey Stanlley, is it possible to use an external amplifier with Heng Long TK 7.0 boards ? ------------ I've tried to plug one to TK7.0 but it gives just some strange noise with distortion and nothing else. If I plug the external amp to an FM radio it plays fine.
@Stanlley Legion I did notice one thing - if I give more power to the external amp I do start to hear a bit the noise of tank but very distorted. Maybe the board amp signal is too strong and I need to weaken it with a potentiometer... ---- From what I see, the amp on TK7.0 board is Mix 2808 using 7.4v it gives 10w with 2ohm speaker and 5w with 4ohm one. So if we cannot connect an external amp to CN9 then the only solution to get 10W will be to connect two 4 ohms speakers in parallel that will give us 2ohms...
@@vadymvorobyov5913 this part honestly no idea, by my very limited understanding is the sound signal output should be from the volume control port and amplified through the amp, but HL boards since v5.3 do not have volume control outputs anymore.
@@StanlleyLegion Hello Stanley, here is my contribution for your help and awesome videos. I figured out that the generic Mix2808 amp (Heng long 6.0 and 7.0) boards supports 2ohm 10W-13W speakers (in reality it will be around 9-10W with 7.4V). ------------------- I did a test - I wired in a !! parallel !! connection 2 speakers (2X 3.6ohm 10W each - Chinese ones so not 4ohm...) which gives 1.8 ohm of impedance and around 1.5 sound boost comparing to the original HL speaker sound. Ideally the impedance of 2 wired speakers should be ! not less than 2ohm ! to be on the safe side but there is not a lot of speakers on the market with this impedance that will feet in the tank that's why 2 speakers did the job.
Why do they “upgrade” to v7 if it is actually removing functionality? Like is there something Im missing? I bought 2 of them (the v6 and the v7) for a friend, thanks for the video very useful.
Great review! In Russia, many of the same opinion about TK 7.0 It's just a show-off ... the 6.0S option was optimal. Everyone was happy with it, and this is a good budget option for infrared combat.
Great review. First review that explains so much. Thanks
...PRETTY COOL...THANKS STANLEY 4 THE UN-BOXING VID!!!!!!!!!!!!!!!!!!!!!!!!!!! :)
The lower hull also has the KV1 uparmour, that some KV1 had. I have never seen a KV2 with the additional armour plates. The swivel opening is a roof ventilator (to extract fumes from the fighting compartment) on the real tank.
I love your tanks. I am 49 and I just got the German Stut III. Really love the detail on the tanks and the ability to upgrade them. I think I may order this one today! Great stuff. Thanks a million for such cool tanks!!
looking forward to hearing from you!
@@StanlleyLegion Hey Stanlley. Absolutely. Thank you for the reply.
Nice marketing skills.
Ahh the KV2. An AWESOME tank!!!
Thx Mate for your Compliments 😂
Love your channel,from the U.S.A!!
An awesome review. You never disappoint. Thank you
Time to track down and purchase some V6 HL tanks for the better sound options. That’s a real shame they have done this.
Great honest review.
KV2 is my biggesssssst love ❤. you should leave KV2!
honest review, not just good good good bababra like other seller.
Can the battery be replaced so that it can play longer?
yes of course, we do this all the time!
@@StanlleyLegion thank you 🙏🏼
Hi Stan, i am figuring what the words on the turret says?
Mine just arrived, it is the Tiger 1 v7.0 and there is an option that says something about double or normal current that when I try to drive the tank it makes it disconnect lol….
Awesome frickin vid man!!
Love the honesty of the review
How long is shipping to the u.s
Id like to buy a tank from you .
About a week
Bosque jenis tank henglong biar ga d upgrade dinamon kuat juga kah buat trabas alas
Would you recommend any specific Tamiya 1/16 RC kits for someone who hasn't ever built one before? I really want their Type 10, but I can't find any for sale anywhere (that doesn't look sketchy)
Tamiya kits are usually limited runs so.. All the best!
Can you recommend a good RTR Tank for a beginner that is good for IR Battles and under $250? Looking for possibly 1/16 scale maybe a little smaller. I saw some online that come in sets but looks very cheap in quality. I was hoping the IR device would be already installed since I am not very mechanically inclined. Thank you for any advice you have.
get any HL v6.0 tank, should be fun out of the box.
@@StanlleyLegion Thank you so much for the great advice!!!
Maybe with a resistor you can delay the recoil until the gun blasts
unfortunately, it's a mechanical thing. The BB motor is the recoil "motor" and the firing only works when the barrel/BB piston goes all the way back. Delaying anything will just delay the entire firing sequence
Hi, I have one question about 7.0 mfu. New 7.0 mfu have the same heat problem like 6.0 mfu when run with high speed motor like 390 motor or not?
It should be fine. It is rated for 60A. 390 motor less than 10A
Woo new video! question, can you use a regular lipo charger to charge the batteries that come with it?
Yes but you need to set to Li-ion mode
I just bought the Heng Long Sherman tank 7.0 ver. The only bad thing is that every time it starts up there is a loud beep (like a Toyota horn) than it starts up. Can that be disabled? I'm still learning all the functions.
nope, that's built in default
Yea i hate the usb charger it destroys the batery
Awesome tank love it
Hopefully the challenger 2 parts Will be back in stock soon
Very awesome
Do you guys ship to Canada? And when is the gun barrel recoil and elevation kit for the T90 going to be in stock again?
Yes we ship to Canada
Unfortunately we no longer sell Clark products
Have you got the T-90 or T-99 1/16 scale in stock?
I have 1 T90 left in stock
When comes the Merkava from Heng Long????
Honestly no idea. Some say mid 2022
Amazing
Someone needs to figure out how to hack the V7 electronics to add custom sound files.
dunno if that's possible :(
Soo... What happened with the Sounds from the 6.0? Did Tamiya finally crack down on HL for ripping off their Sound Files and they now have to rely on the only two they recorded themselves or what?
No idea really
Hey Stanlley, is it possible to use an external amplifier with Heng Long TK 7.0 boards ?
------------
I've tried to plug one to TK7.0 but it gives just some strange noise with distortion and nothing else. If I plug the external amp to an FM radio it plays fine.
unfortunately no
@Stanlley Legion I did notice one thing - if I give more power to the external amp I do start to hear a bit the noise of tank but very distorted. Maybe the board amp signal is too strong and I need to weaken it with a potentiometer...
----
From what I see, the amp on TK7.0 board is Mix 2808 using 7.4v
it gives 10w with 2ohm speaker and 5w with 4ohm one. So if we cannot connect an external amp to CN9 then the only solution to get 10W will be to connect two 4 ohms speakers in parallel that will give us 2ohms...
@@vadymvorobyov5913 this part honestly no idea, by my very limited understanding is the sound signal output should be from the volume control port and amplified through the amp, but HL boards since v5.3 do not have volume control outputs anymore.
@@StanlleyLegion Hello Stanley, here is my contribution for your help and awesome videos. I figured out that the generic Mix2808 amp (Heng long 6.0 and 7.0) boards supports 2ohm 10W-13W speakers (in reality it will be around 9-10W with 7.4V).
-------------------
I did a test - I wired in a !! parallel !! connection 2 speakers (2X 3.6ohm 10W each - Chinese ones so not 4ohm...) which gives 1.8 ohm of impedance and around 1.5 sound boost comparing to the original HL speaker sound. Ideally the impedance of 2 wired speakers should be ! not less than 2ohm ! to be on the safe side but there is not a lot of speakers on the market with this impedance that will feet in the tank that's why 2 speakers did the job.
@@vadymvorobyov5913 wow that is great work sir. You must be subject matter expert!
Does model code 3949.1 mean v7? Thanks 😊
@@darrenstopler3045 no, it just identifies the tank model, which is the KV2
Those are v7.0 (because they are new)
ive got the king tiger 7.0 and it haves it own set of sounds and they sound really good and like what you'd expect for it not like my tiger 1- 7.0
oh that's interesting
@@StanlleyLegion I can send a video???
@@201MF you can upload the video on your RUclips channel and send me the link
@@StanlleyLegion ok will do 😊😊
Here we go ruclips.net/user/shortsEhEVpH_MlRk?feature=share
Yahoo! Thank ou. this is perfect upload, fellow,😈
Why do they “upgrade” to v7 if it is actually removing functionality? Like is there something Im missing?
I bought 2 of them (the v6 and the v7) for a friend, thanks for the video very useful.
apparently more features were added but I can't seen to actually tell the difference!
You have for sale ?
Link in the description
@@StanlleyLegion disappointed in this tank. The sound is aweful
@@kennethmeyers5008 don't blame me
Is there the KV-2 on 2.4 Ghz with the fourth generation in the plastic version? What do I want with gas turbine sound, so unrealistic!
Better put the new Elmod fusion X in , or buy a separate HL electronic system
Does a 6.0 board wire directly into a 7.0 tank ? 😆
Yes all the same wiring except for the IR receiver. You need to change the radio too
no smoke?
Yes smoke is included
Macam mana nak beli boss?ada online shop ke?
Www.rctanklegion.com
Two sounds, Leopard and Abrams. And the tank model is a russian KV-2, WW2. I prefer Taigen with IS-2 Sound, that´s much more realistic.
Challenger2 actually
KV2 are awesome...but the Turbine sound are nonsense
Probebly copyright issues
maybe you should RTFM, Stan....lol
The sound is a shame
HL really pissed everyone off with the stupid 7.0 board.
@@redpillscholar560 yeah we called it 7.stupid
Dommage que se n'est pas traduit en français 😕
Does it come with instructions 🤣
Yes it does
Should now your product before making a review.
DJI
DJI DJI DJI DJI DJI