FPV SpeedyBee Mario 5 DC Pro Version use INAV Position Hold

[@flyOnMap]

All TPUs are designed by me with Blender

[@alikavari351]

do you use any rangefinder (sonar sensor) or just using barometer for altitiute estimation

[@terradroidOnAir]

It use only Barometer and Magentometer

[@Wontonsoupz]

What stacks do you have to use in order to install INAV for position hold?

[@terradroidOnAir]

SpeedyBee F7 V3 BL32 50A 30x30 Stack

[@zdenekhauf7768]

How you axtive this mood?

[@flyOnMap]

In INAV 7.1.x You can use PosHold, Navigation and RTH without compass PSA. Then you activate this in your Models.

[@srilankanlines]

What are the modes you have activated bro. how do you activated those modes. one by one or together. plz explain when u have time

[@flyOnMap]

Model for Rear is hier www.printables.com/model/919841-fpv-speedybee-mario-5-custom-tpu-for-xt60-iflight

[@BriiandMdz]

Where did you buy the Tpu?

[@vigneshwaran9775]

Can I get the tpu design for 3d print plzz help me on this

[@terradroidOnAir]

Thanks for interest on my work, i must prepare all tpus.

[@technicalsupport6983]

Which Gps used ?

[@flyOnMap]

I use hier BLITZ M10 GPS V2,

[@sensivityable]

This is awesome. Bardwell had issues with his compass when it's close to the battery and XT60 connector. Did you have this issue?

[@tylerboyer4167]

My compositor fit right in

[@terradroidOnAir]

you can see on this video, with little antennas i have no problems, with longer antennas i must longer wait for founding of gps satellites