Always dry fit the boxes to check the level before installing with resin. If too high, route deeper. Our install kits have adjustable collars so you can dial in the depth. If already installed into the board just move forward and be careful when sanding not to cut into the boxes. If the fin bases are high off the board you can sand down the tabs to bring them flush with the bottom so water doesn't slip under and reduce your drive.
Well done Sir & I am Replacing a FCS Fusion plug & want to experiment Fusion 9 , FCS 2 or keep it with the same Fusion FCS plug ? i like bigger plug to cover the loss of the foam ,
@@GreenlightSurfSupply Thanks , Did the Fusion originals Right fin plugs came with cant options or where they all 0 cant for the 1st generation Fusions ?
@@GreenlightSurfSupply I just talked to the shaper of this surfboard and he is very cool & did send me to you to get resin etc , his name is Brian Wynn .anyways hanks for the info and will place an order if I fix her up .
This kit made it super easy to do. 10/10 I did mine after glassing the bottom because I did a resin tint looks great
Glad your board came out nice!
Really helpful video, thanks!
Let us know if you have any additional questions 🤙🏽
What would you recommend if the fusion boxes are sitting slightly above the foam, as opposed to sitting too deep?
Always dry fit the boxes to check the level before installing with resin. If too high, route deeper. Our install kits have adjustable collars so you can dial in the depth. If already installed into the board just move forward and be careful when sanding not to cut into the boxes.
If the fin bases are high off the board you can sand down the tabs to bring them flush with the bottom so water doesn't slip under and reduce your drive.
Well done Sir & I am Replacing a FCS Fusion plug & want to experiment Fusion 9 , FCS 2 or keep it with the same Fusion FCS plug ? i like bigger plug to cover the loss of the foam ,
Keep it Fusion unless replacing all the plugs with FCS2
@@GreenlightSurfSupply Thanks , Did the Fusion originals Right fin plugs came with cant options or where they all 0 cant for the 1st generation Fusions ?
They've been 9, 5, and zero degree options from the beginning...
@@GreenlightSurfSupply I just talked to the shaper of this surfboard and he is very cool & did send me to you to get resin etc , his name is Brian Wynn .anyways hanks for the info and will place an order if I fix her up .